- 您現在的位置：買賣IC網 > PDF目錄360998 > ISP1181 (NXP Semiconductors N.V.) Full-speed Universal Serial Bus Interface Device(全速通用串行總線接口器件) PDF資料下載
參數資料
| 型號： | ISP1181 |
| 廠商： | NXP Semiconductors N.V. |
| 英文描述： | Full-speed Universal Serial Bus Interface Device(全速通用串行總線接口器件) |
| 中文描述： | 全速通用串行總線接口設備（全速通用串行總線接口器件） |
| 文件頁數： | 35/69頁 |
| 文件大小： | 1655K |
| 代理商： | ISP1181 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁當前第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁
Philips Semiconductors
ISP1181
Full-speed USB interface
Objective specification
Rev. 01 — 13 March 2000
35 of 69
9397 750 06896
Philips Electronics N.V. 2000. All rights reserved.
12.2.4
Clear Endpoint Buffer
This command unlocks and clears the buffer of the selected OUT endpoint, allowing
the reception of new packets. Reception of a complete packet causes the Buffer Full
flag of an OUT endpoint to be set. Any subsequent packets are refused by returning a
NAK condition, until the buffer is unlocked using this command. For a double-buffered
endpoint this command switches the current FIFO for CPU access.
Remark:
For special aspects of the control OUT endpoint see
Section 9.5
.
Code (Hex): 70, 72 to 7F —
clear endpoint buffer (control OUT, endpoint 1 to 14)
Transaction —
none
12.2.5
Check Endpoint Status
This command is used to check the status of the selected endpoint FIFO without
clearing any status or interrupt bits. The command accesses the Endpoint Status
Image Register, which contains a copy of the Endpoint Status Register. The bit
allocation of the Endpoint Status Image Register is shown in
Table 35
.
Code (Hex): D0 to DF —
check status (control OUT, control IN, endpoint 1 to 14)
Transaction —
write/read 1 byte
Table 35: Endpoint Status Image Register: bit allocation
Bit
7
Symbol
EPSTAL
EPFULL1
6
5
4
3
2
1
0
EPFULL0
reserved
OVER
WRITE
0
R
SETUPT
CPUBUF
reserved
Reset
Access
0
R
0
R
0
R
0
R
0
R
0
R
0
R
Table 36: Endpoint Status Image Register: bit description
Bit
Symbol
Description
7
EPSTAL
This bit indicates whether the endpoint is stalled or not
(1 = stalled, 0 = not stalled).
6
EPFULL1
A logic 1 indicates that the secondary endpoint buffer is full.
5
EPFULL0
A logic 1 indicates that the primary endpoint buffer is full.
4
-
reserved
3
OVERWRITE
This bit is set by hardware, a logic 1 indicating that a new Setup
packet has overwritten the previous setup information, before it
was acknowledged or before the endpoint was stalled. This bit is
cleared by reading, if writing the setup data has finished.
Firmware must check this bit before sending an Acknowledge
Setup command or stalling the endpoint. Upon reading a logic 1
the firmware must stop ongoing setup actions and wait for a new
Setup packet.
2
SETUPT
A logic 1 indicates that the buffer contains a Setup packet.
1
CPUBUF
This bit indicates which buffer is currently selected for CPU
access (0 = primary buffer, 1 = secondary buffer).
0
-
reserved
相關PDF資料 |
PDF描述 |
|---|---|
| ISP1181DGG | INDUCTOR 4.7NH +-.3NH 0402 SMD |
| ISP1183 | Low-power Universal Serial Bus interface device with DMA |
| ISP1183BS | Low-power Universal Serial Bus interface device with DMA |
| ISP1301 | Universal Serial Bus On-The-Go transceiver |
| ISP1301BS | Universal Serial Bus On-The-Go transceiver |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISP1181A | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Full-speed Universal Serial Bus peripheral controller |
| ISP1181ABS | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Full-speed Universal Serial Bus peripheral controller |
| ISP1181ABS,518 | 功能描述:USB 接口集成電路 USB 1.1 ADV DEVICE RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20 |
| ISP1181ABS,551 | 功能描述:USB 接口集成電路 USB 1.1 ADVANCED DEVICE RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20 |
| ISP1181ABS,557 | 功能描述:USB 接口集成電路 DO NOT USE ORDER -S OR -T PART RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20 |
發布緊急采購，3分鐘左右您將得到回復。