
Revision 1.0
31
www.national.com
L
12.0 Command Interface
(Continued)
Table 39. Local Service Database Configuration Commands
Command
Event
Description
Store SPP Record
Store SPP Record Confirm
Create a new SPP record within the service
database
Store DUN Record
Store DUN Record Confirm
Create a new DUN record within the service
database
Store FAX Record
Store FAX Record Confirm
Create a new FAX record within the service
database
Store OPP Record
Store OPP Record Confirm
Create a new OPP record within the service
database
Store FTP Record
Store FTP Record Confirm
Create a new FTP record within the service
database
Store IrMCSync Record
Store IrMCSync Record Confirm
Create a new IrMCSync record within the ser-
vice database
Enable SDP Record
Enable SDP Record Confirm
Enable or disable SDP records
Delete All SDP Records
Delete All SDP Records Confirm
Ports to Open
Ports to Open Confirmed
Specify the RFComm Ports to open on
startup
Table 40. Local Hardware Commands
Command
Event
Description
Set Default Audio Settings
Set Default Audio Settings Confirm
Configure default settings for audio codec
and air format, stored in NVS
Get Default Audio Settings
Get Default Audio Settings Confirm
Get stored default audio settings
Set Event Filter
Set Event Filter Confirm
Configures the reporting level of the
command interface
Get Event Filter
Get Event Filter Confirm
Get the status of the reporting level
Read RSSI
Read RSSI Confirm
Returns an indicator for the incoming signal
strength
Change UART Speed
Change UART Speed Confirm
Set specific UART speed; needs proper ISEL
pin setting
Change UART Settings
Change UART Settings Confirm
Change configuration for parity and stop bits
Test Mode
Test Mode Confirm
Enable Bluetooth, EMI test, or local loopback
Restore Factory Settings
Restore Factory Settings Confirm
Reset
Dongle Ready
Soft reset
Firmware Upgrade
Stops the Bluetooth firmware and executes
the in-system programming code