- 您現在的位置：買賣IC網 > PDF目錄382289 > MBM29PL12LM10PBT (Fujitsu Limited) FLASH MEMORY 128 M (16M ?8/8M ?16) BIT PDF資料下載
參數資料
| 型號： | MBM29PL12LM10PBT |
| 廠商： | Fujitsu Limited |
| 英文描述： | FLASH MEMORY 128 M (16M ?8/8M ?16) BIT |
| 中文描述： | 快閃記憶體128米（1,600？8/8M？16）位 |
| 文件頁數： | 32/72頁 |
| 文件大小： | 1036K |
| 代理商： | MBM29PL12LM10PBT |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁當前第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁
MBM29PL12LM
10
32
Extended Sector Group Protection
In addition to normal sector group protection, the device has Extended Sector Group Protection as extended
function. This function enables protection of the sector group by forcing V
ID
on RESET pin and writes a command
sequence. Unlike conventional procedures, it is not necessary to force V
ID
and control timing for control pins.
The only RESET pin requires V
ID
for sector group protection in this mode. The extended sector group protection
requires V
ID
on RESET pin. With this condition, the operation is initiated by writing the set-up command (60h)
into the command register. Then the sector group addresses pins (A
22
, A
21
, A
20
, A
19
, A
18
, A
17,
A
16
and A
15
) and
(A
6
, A
3
, A
2
, A
1
, A
0
) = (0, 0, 0, 1, 0) should be set to the sector group to be protected (set V
IL
for the other addresses
pins is recommended), and write extended sector group protection command (60h). A sector group is typically
protected in 250
μ
s. To verify programming of the protection circuitry, the sector group addresses pins (A
6
, A
3
,
A
2
, A
1
, A
0
) = (0, 0, 0, 1, 0) should be set and write a command (40h). Following the command write, a logical “1”
at device output DQ
0
will produce for protected sector in the read operation. If the output data is logical “0”, write
the extended sector group protection command (60h) again. To terminate the operation, set RESET pin to V
IH
.
(Refer to the “Extended Sector Group Protection Timing Diagram” in
■
TIMING DIAGRAM and “Extended Sector
Group Protection Algorithm” in
■
FLOW CHART.)
Query Command (CFI : Common Flash Memory Interface)
The CFI (Common Flash Memory Interface) specification outlines device and host system software interrogation
handshake which allows specific vendor-specified software algorithms to be used for entire families of devices.
This allows device-independent, JEDEC ID-independent, and forward-and backward-compatible software sup-
port for the specified flash device families. Refer to CFI specification in detail.
The operation is initiated by writing the query command (98h) into the command register. Following the command
write, a read cycle from specific address retrieves device information. Please note that output data of upper byte
(DQ
15
to DQ
8
) is “0”. Refer to the CFI code table. To terminate operation, it is necessary to write the Reset
command sequence into the register. (See “Common Flash Memory Interface Code” in
■
DEVICE BUS OPER-
ATION.)
相關PDF資料 |
PDF描述 |
|---|---|
| MBM29PL12LM10PCN | FLASH MEMORY 128 M (16M ?8/8M ?16) BIT |
| MBM30LV0064-PFTN | 64M (8M X 8) BIT NAND-type |
| MBM30LV0064-PFTR | 64M (8M X 8) BIT NAND-type |
| MBM30LV0032 | 32M (4M X 8) BIT NAND-type |
| MBM30LV0032-PFTN | 32M (4M X 8) BIT NAND-type |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MBM30000 | 功能描述:BRACKET SIDE MOUNT RoHS:是 類別:工業控制，儀表 >> 配件 系列:* 標準包裝:1 系列:Aero-Motive® 130117 附件類型:拖車帶 適用于相關產品:標準盒式跟蹤系統 其它名稱:WM6183 |
| MBM30035001 | 制造商:LG Corporation 功能描述:Card,Technical |
| MBM30035015 | 制造商:LG Corporation 功能描述:Card,Technical |
| MBM300A6 | 制造商:HITACHI 制造商全稱:Hitachi Semiconductor 功能描述:IGBT MODULE RANGE WITH SOFT AND FAST (SFD) FREE-WHEELING DIODES |
| MBM300GR12A | 制造商:n/a 功能描述:IGBT Module |
發布緊急采購，3分鐘左右您將得到回復。