- 您現在的位置：買賣IC網 > PDF目錄382686 > TSB12C01APZ (Texas Instruments, Inc.) High-Speed Serial-Bus Link-Layer Controller PDF資料下載
參數資料
| 型號： | TSB12C01APZ |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | High-Speed Serial-Bus Link-Layer Controller |
| 中文描述： | 高速串行總線鏈路層控制器 |
| 文件頁數： | 22/59頁 |
| 文件大小： | 275K |
| 代理商： | TSB12C01APZ |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁當前第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁
3–6
Set
Clear
Clk
PhInt Bit
Interrupt Bit (INT)
Other
Interrupts
Interrupt Bit
IntMask Bit
PhInt Bit
PhIntMask Bit
INT
DATA (01)
CS
WR
PhInt Source
SCLK
Q
Figure 3–2. Interrupt Logic Diagram Example
Table 3–4. Interrupt- and Mask-Register Field Descriptions
BITS
ACRONYM
FUNCTION NAME
DESCRIPTION
0
Int
Interrupt
Int contains the value of all interrupt and interrupt mask bits ORed
together.
1
PhInt
Phy chip interrupt
When PhInt is set, the phy chip has signaled an interrupt through the
Phy interface.
2
PhyRRx
Phy register
information received
When PhyRRx is set, a register value has been transferred to the phy
chip access register (offset 24h) from the phy interface.
3
PhRst
Phy reset started
When PhRst is set, a phy-layer reconfiguration has started (1394 bus
reset).
4
Reserved
Reserved
Reserved
5
TxRdy
Transmitter ready
When TxRdy is set, the transmitter is idle and ready.
6
RxDta
Receiver has data
In normal mode and when set, RxDta indicates that the receiver has
accepted a quadlet of data into the GRF interface. This bit is set each
time a quadlet of data is accepted. However, during the self-ID portion
of a bus reset, this bit is set after each complete self-ID packet is
received into the GRF.
7
CmdRst
Command reset
received
When CmdRst is set, the receiver has been sent a quadlet write
request addressed to the RESET_START CSR register.
8–10
Reserved
Reserved
Reserved
11
ITStk
Transmitter is stuck
(IT)
When ITStk is set, the transmitter has detected invalid data at the
isochronous transmit-FIFO interface.
12
ATStk
Transmitter is stuck
(AT)
When ATStk is set, the transmitter has detected invalid data at the
asynchronous transmit-FIFO interface. If the first quadlet of a packet
is not written to the ATF_First or ATF_First&Update, the transmitter
enters a state denoted by an ATStuck interrupt. An underflow of the
ATF also causes an ATStuck interrupt. If this state is entered, no
asynchronous packets can be sent until the ATF is cleared by way of
the CLR ATF control bit. Isochronous packets can be sent while in this
state.
相關PDF資料 |
PDF描述 |
|---|---|
| TSB12C01AWN | High-Speed Serial-Bus Link-Layer Controller |
| TSB12LV01APZ | High-Speed Serial-Bus Link-Layer Controller |
| TSB3055 | IC APEX 20KE FPGA 300K 240-PQFP |
| TSB41AB3 | IC APEX 20KE FPGA 400K 672-FBGA |
| TSB41BA3-EP | IC APEX 20KE FPGA 400K 672-FBGA |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TSB12C01AWN | 制造商:TI 制造商全稱:Texas Instruments 功能描述:High-Speed Serial-Bus Link-Layer Controller |
| TSB12LV01A | 制造商:Texas Instruments 功能描述: |
| TSB12LV01AIPZ | 制造商:TI 制造商全稱:Texas Instruments 功能描述:IEEE 1394 (Firewire) Bus Interface/Controller |
| TSB12LV01APZ | 制造商:TI 制造商全稱:Texas Instruments 功能描述:High-Speed Serial-Bus Link-Layer Controller |
| TSB12LV01B | 制造商:TI 制造商全稱:Texas Instruments 功能描述:IEEE 1394-1995 HIGH SPEED SERIAL BUS LINK LAYER CONTROLLER |
發布緊急采購，3分鐘左右您將得到回復。