3-4 Revision 13 Table 3-1 shows the Flash*Freeze pin location on the available packages. The Flash*Freeze pin locat" />

欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: AGLE600V2-FGG484
廠商: Microsemi SoC
文件頁數: 33/166頁
文件大小: 0K
描述: IC FPGA IGLOOE 1.2-1.5V 484FPBG
標準包裝: 60
系列: IGLOOe
邏輯元件/單元數: 13824
RAM 位總計: 110592
輸入/輸出數: 270
門數: 600000
電源電壓: 1.14 V ~ 1.575 V
安裝類型: 表面貼裝
工作溫度: 0°C ~ 70°C
封裝/外殼: 484-BGA
供應商設備封裝: 484-FPBGA(23x23)
其它名稱: 1100-1119
Pin Descriptions and Packaging
3-4
Revision 13
Table 3-1 shows the Flash*Freeze pin location on the available packages. The Flash*Freeze pin location
is independent of device (except for a PQ208 package), allowing migration to larger or smaller IGLOO
devices while maintaining the same pin location on the board. Refer to the "Flash*Freeze Technology
and Low Power Modes" chapter of the IGLOOe FPGA Fabric User’s Guide for more information on I/O
states during Flash*Freeze mode.
JTAG Pins
Low power flash devices have a separate bank for the dedicated JTAG pins. The JTAG pins can be run
at any voltage from 1.5 V to 3.3 V (nominal). VCC must also be powered for the JTAG state machine to
operate, even if the device is in bypass mode; VJTAG alone is insufficient. Both VJTAG and VCC to the
part must be supplied to allow JTAG signals to transition the device. Isolating the JTAG power supply in a
separate I/O bank gives greater flexibility in supply selection and simplifies power supply and PCB
design. If the JTAG interface is neither used nor planned for use, the VJTAG pin together with the TRST
pin could be tied to GND.
TCK
Test Clock
Test clock input for JTAG boundary scan, ISP, and UJTAG. The TCK pin does not have an internal pull-
up/-down resistor. If JTAG is not used, Microsemi recommends tying off TCK to GND through a resistor
placed close to the FPGA pin. This prevents JTAG operation in case TMS enters an undesired state.
Note that to operate at all VJTAG voltages, 500
to 1 k will satisfy the requirements. Refer to Table 3-2
for more information.
Table 3-1 Flash*Freeze Pin Locations for IGLOOe Devices
Package
Flash*Freeze Pin
FG256
T3
FG484
W6
FG896
AH4
Table 3-2 Recommended Tie-Off Values for the TCK and TRST Pins
VJTAG
Tie-Off Resistance 1,2
VJTAG at 3.3 V
200
to 1 k
VJTAG at 2.5 V
200
to 1 k
VJTAG at 1.8 V
500
to 1 k
VJTAG at 1.5 V
500
to 1 k
Notes:
1. The TCK pin can be pulled-up or pulled-down.
2. The TRST pin is pulled-down.
3. Equivalent parallel resistance if more than one device is on the JTAG chain
相關PDF資料
PDF描述
AIML-0603-56NK-T INDUCTOR MULTILAYER 56NH 0603
HAZ151MBACRBKR CAP CER 150PF 1KV 20% RADIAL
HAZ151MBABREKR CAP CER 150PF 1KV 20% RADIAL
8-1624112-7 INDUCTOR .11UH 5% 0603
TAP476K020CRW CAP TANT 47UF 20V 10% RADIAL
相關代理商/技術參數
參數描述
AGLE600V2-FGG484I 功能描述:IC FPGA 1KB FLASH 600K 484-FBGA RoHS:是 類別:集成電路 (IC) >> 嵌入式 - FPGA(現場可編程門陣列) 系列:IGLOOe 產品培訓模塊:Three Reasons to Use FPGA's in Industrial Designs Cyclone IV FPGA Family Overview 特色產品:Cyclone? IV FPGAs 標準包裝:60 系列:CYCLONE® IV GX LAB/CLB數:9360 邏輯元件/單元數:149760 RAM 位總計:6635520 輸入/輸出數:270 門數:- 電源電壓:1.16 V ~ 1.24 V 安裝類型:表面貼裝 工作溫度:0°C ~ 85°C 封裝/外殼:484-BGA 供應商設備封裝:484-FBGA(23x23)
AGLE600V2-FGG896 制造商:ACTEL 制造商全稱:Actel Corporation 功能描述:IGLOOe Low-Power Flash FPGAs with Flash Freeze Technology
AGLE600V2-FGG896ES 制造商:ACTEL 制造商全稱:Actel Corporation 功能描述:IGLOOe Low-Power Flash FPGAs with Flash Freeze Technology
AGLE600V2-FGG896I 制造商:ACTEL 制造商全稱:Actel Corporation 功能描述:IGLOOe Low-Power Flash FPGAs with Flash Freeze Technology
AGLE600V2-FGG896PP 制造商:ACTEL 制造商全稱:Actel Corporation 功能描述:IGLOOe Low-Power Flash FPGAs with Flash Freeze Technology
主站蜘蛛池模板: 天台县| 宝应县| 江都市| 十堰市| 中卫市| 集贤县| 凤凰县| 成都市| 伽师县| 辛集市| 连州市| 诸城市| 黄浦区| 雷波县| 巫溪县| 含山县| 南投市| 临沧市| 长沙县| 额尔古纳市| 马龙县| 凉城县| 古蔺县| 顺义区| 霞浦县| 济阳县| 绵竹市| 南召县| 古蔺县| 宜宾市| 东兰县| 施秉县| 广南县| 张家界市| 武宣县| 博爱县| 溧阳市| 太仆寺旗| 呼伦贝尔市| 鄂托克前旗| 咸阳市|