- 您現在的位置：買賣IC網 > PDF目錄385345 > GS9092ACNE3 (Gennum Corporation) GS9092A GenLINX-R III 270Mb/s Serializer for SDI and DVB-ASI PDF資料下載
參數資料
| 型號： | GS9092ACNE3 |
| 廠商： | Gennum Corporation |
| 英文描述： | GS9092A GenLINX-R III 270Mb/s Serializer for SDI and DVB-ASI |
| 中文描述： | GS9092A GenLINX - R的第三270Mb / s的串行SDI和DVB - ASI在內 |
| 文件頁數： | 46/59頁 |
| 文件大小： | 614K |
| 代理商： | GS9092ACNE3 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁當前第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁
GS9092A Data Sheet
34715 - 0
February 2006
46 of 59
3.10 Serial Digital Output
The GS9092A contains an integrated current mode differential serial digital output
buffer/cable driver, capable of driving 800mV into two single ended 75
Ω
loads.
Output pins SDO and SDO provide a single differential serial digital output.
Alternatively, two 75
Ω
connections can be driven using single ended drive.
To enable the output, SDO_EN must be set HIGH by the application layer. Setting
the SDO_EN signal LOW will cause the SDO and SDO output pins to become high
impedance, resulting in reduced device power consumption.
With suitable external return loss matching circuitry, the GS9092A's serial digital
outputs will provide a minimum output return loss of 15dB.
The output buffer / cable driver uses a separate power supply of +1.8V DC supplied
via the CD_VDD and CD_GND pins.
3.10.1 Output Swing
Nominally, the voltage swing of the serial digital output is 800mV
p-p
single-ended
into a 75
Ω
load. This is set externally by connecting the RSET pin to CD_VDD
through a resistor. The output swing may be adjusted by altering the value of the
RSET resistor.
SMPTE-compliant cable driver operation can be achieved at +1.8V operation by
connecting external pull-up resistors from the differential output to the +1.8V
source.
3.10.2 Serial Digital Output Mute Control
The GS9092A will automatically mute the serial digital output when RESET is
LOW. In this case, the SDO and SDO signals are set to the last logic state.
3.10.3 Output Return Loss Measurement
Under normal operating conditions the cable connected to the BNC connector will
provide a 75
Ω
load. Under this loaded condition, the outputs of the device swing
between V
CC
-0.4V and V
CC
-1.2V. When a 75
Ω
load is not connected to the BNC
connector, the outputs of the device will swing between V
CC
and V
CC
- 1.6V. The
difference in output swing is shown in
Figure 3-10
.
相關PDF資料 |
PDF描述 |
|---|---|
| GS9092 | GS9092 GenLINX-R III 270Mb/s Serializer for SDI and DVB-ASI |
| GS9092-CNE3 | GS9092 GenLINX-R III 270Mb/s Serializer for SDI and DVB-ASI |
| GSC9620 | P-CHANNEL ENHANCEMENT MODE POWER MOSFET |
| GSD2004S-V-GS08 | DIODE 0.225 A, 300 V, 2 ELEMENT, SILICON, SIGNAL DIODE, TO-236AB, ROHS COMPLIANT, PLASTIC PACKAGE-3, Signal Diode |
| GSD2004S-V-GS18 | DIODE 0.225 A, 300 V, 2 ELEMENT, SILICON, SIGNAL DIODE, TO-236AB, ROHS COMPLIANT, PLASTIC PACKAGE-3, Signal Diode |
相關代理商/技術參數 |
參數描述 |
|---|---|
| GS9092ACNTE3 | 制造商:Semtech Corporation 功能描述:270Mb/s Transmitter for SDI & ASI |
| GS9092CNE3 | 制造商:Gennum Corporation 功能描述: |
| GS9092-CNE3 | 制造商:Rochester Electronics LLC 功能描述: 制造商:Gennum Corporation 功能描述: |
| GS90A12-P1M | 功能描述:插入式交流適配器 80W 12V 6.67A RoHS:否 制造商:Phihong 地區:Universal 安裝風格:Wall, Interchangeable Plug 輸入電壓范圍:90 VAC to 264 VAC 輸出端數量:1 輸出功率額定值:5 W 輸出電壓（通道 1）:5 V 輸出電流（通道 1）:1 A 直流輸出連接器:USB Type A 隨附/必需的交流插頭:Required 商用/醫用:Commercial 效率:Level V |
| GS90A15-P1M | 功能描述:插入式交流適配器 90W 15V 6A RoHS:否 制造商:Phihong 地區:Universal 安裝風格:Wall, Interchangeable Plug 輸入電壓范圍:90 VAC to 264 VAC 輸出端數量:1 輸出功率額定值:5 W 輸出電壓（通道 1）:5 V 輸出電流（通道 1）:1 A 直流輸出連接器:USB Type A 隨附/必需的交流插頭:Required 商用/醫用:Commercial 效率:Level V |
發布緊急采購，3分鐘左右您將得到回復。