欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: MC68C912B32CFU8
廠商: MOTOROLA INC
元件分類: 微控制器/微處理器
英文描述: 16-Bit Microcontroller
中文描述: 16-BIT, FLASH, 8 MHz, MICROCONTROLLER, PQFP80
封裝: QFP-80
文件頁數: 57/128頁
文件大?。?/td> 748K
代理商: MC68C912B32CFU8
MC68HC912B32
MC68HC912B32TS/D
MOTOROLA
57
10 Clock Functions
Clock generation circuitry generates the internal and external E-clock signals as well as internal clock
signals used by the CPU and on-chip peripherals. A clock monitor circuit, a computer operating properly
(COP) watchdog circuit, and a periodic interrupt circuit are also incorporated into the MC68HC912B32.
10.1 Clock Sources
A compatible external clock signal can be applied to the EXTAL pin or the MCU can generate a clock
signal using an on-chip oscillator circuit and an external crystal or ceramic resonator. The MCU uses
three types of internal clock signals derived from the primary clock signal: T clocks, E clock, and P clock.
The T clocks are used by the CPU. The E and P clocks are used by the bus interfaces, BDM, SPI, and
ATD. The P clock also drives on-chip modules such as the timer chain, SCI, RTI, COP, and restart-from-
stop delay time.
Figure 10
shows clock timing relationships.
Figure 10 Internal Clock Relationships
10.2 Computer Operating Properly (COP)
The COP or watchdog timer is an added check that a program is running and sequencing properly.
When the COP is being used, software is responsible for keeping a free-running watchdog timer from
timing out. If the watchdog timer times out it is an indication that the software is no longer being execut-
ed in the intended sequence; thus a system reset is initiated. Three control bits allow selection of seven
COP time-out periods or COP disable. When COP is enabled, sometime during the selected period the
program must write $55 and $AA (in this order) to the COPRST register. If the program fails to do this
the part will reset. If any value other than $55 or $AA is written to COPRST, the part is reset.
10.3 Real-Time Interrupt
There is a real-time (periodic) interrupt available to the user. This interrupt will occur at one of seven
selected rates. An interrupt flag and an interrupt enable bit are associated with this function. There are
three bits for the rate select.
10.4 Clock Monitor
The clock monitor circuit is based on an internal resistor-capacitor (RC) time delay. If no MCU clock
edges are detected within this RC time delay, the clock monitor can optionally generate a system reset.
The clock monitor function is enabled/disabled by the CME control bit in the COPCTL register. This
time-out is based on an RC delay so that the clock monitor can operate without any MCU clocks.
Clock monitor time-outs are shown in
Table 19
.
T1CLK
T2CLK
T3CLK
T4CLK
INT ECLK
PCLK
HC12B32 CLOCK RELATIONS
相關PDF資料
PDF描述
MC68CK338 Highly Integrated, Low-Power, 32-Bit Microcontroller
MC68EC060 32-Bit Microprocessors.(32位微處理器)
MC68EN360RC25V QUad Integrated Communications Controller Users Manual
MC68EN360CFE25 QUad Integrated Communications Controller Users Manual
MC68EN360FE25 AC 4C 4#12 PIN PLUG 023
相關代理商/技術參數
參數描述
MC68C912B32FU8 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:16-Bit Microcontroller
MC68CK16Z1 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:M68HC16Z Series
MC68CK16Z1CAG16 功能描述:16位微控制器 - MCU 16BIT 1KRAM 32KHZ CRYSTAL RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT
MC68CK16Z1CAG16 制造商:Freescale Semiconductor 功能描述:Microcontroller
MC68CK16Z1CFC16 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:M68HC16Z Series
主站蜘蛛池模板: 宁南县| 马鞍山市| 尉氏县| 东丽区| 团风县| 容城县| 承德县| 金沙县| 汝城县| 安西县| 茂名市| 庐江县| 治多县| 大余县| 麻阳| 贵溪市| 南乐县| 柞水县| 黎川县| 冕宁县| 宁远县| 彰化市| 双江| 龙川县| 宁远县| 尉氏县| 昭苏县| 金溪县| 昌江| 左权县| 吉木萨尔县| 宾阳县| 上蔡县| 永城市| 自贡市| 寻乌县| 连南| 武功县| 天峨县| 呼和浩特市| 那坡县|