- 您現在的位置：買賣IC網 > PDF目錄361091 > NCP1381DR2G (ON SEMICONDUCTOR) Low−Standby High Performance PWM Controller PDF資料下載
參數資料
| 型號： | NCP1381DR2G |
| 廠商： | ON SEMICONDUCTOR |
| 元件分類： | 穩壓器 |
| 英文描述： | Low−Standby High Performance PWM Controller |
| 中文描述： | 1 A SWITCHING CONTROLLER, 125 kHz SWITCHING FREQ-MAX, PDSO14 |
| 封裝： | LEAD FREE, SOIC-14 |
| 文件頁數： | 16/26頁 |
| 文件大?。?/td> | 559K |
| 代理商： | NCP1381DR2G |
NCP1381
http://onsemi.com
16
100
100
300
500
700
Figure 22. Plateau Sensing Overvoltage Protection
Figure 23. Typical Sensed Waveforms
TIME ( S)
I
P
T
samp
58.5
62.5
66.5
70.4
74.4
+
V
latchdem
Latch
Input
To Demag
Comp.
DRV
Demag
1 Shot
Timer
+
External Latchoff
By lifting up Pin 5 above V
latch
(3.5 V typical), the circuit
is permanently latched. That is to say, Pin 9 goes low, the
GTS pin no longer supplies the PFC and the V
CC
is clamped
to 6 V. The latch reset occurs when V
CC
falls below 4 V, e.g.
when the user unplugs the converter from the mains.
Figure 24 shows several options on how to connect a PNP
to implement an OVP or Overtemperature Protection
(OTP).
Figure 24. Wiring a PNP Transistor on the Skip Cycle Input Pin will Latch the Circuit.
+
V
latch
Skip
NTC
Latch
V
max
< 5 V!
V
ref
OVP
V
ref
+
Skip
+
Latch
OVP
Skip
V
latch
+
Keep in mind that the 5 V maximum limit on all low
voltage pins implies some precaution when triggering the
latch voltage. The cheapest option is obtained when wiring
a simple zener diode in series with the monitored line. Care
must be taken to limit the excursion of the skip pin before
fully latching the controller.
GoToStandby detection
The PFC frontend stage delivers an elevated voltage to
the Flyback converter and keeps the mains power factor
close to unity. However, in standby, this PFC stage is no
longer needed and must be turned off to save watts and thus
reduce the noload standby power. To detect when the
converter enters standby, the controller observes the voltage
available on Pin 1: typically, a portion of the feedback
voltage will be used. In higher power conditions, this level
相關PDF資料 |
PDF描述 |
|---|---|
| NCP1395APG | High Performance Resonant Mode Controller |
| NCP1395ADR2G | High Performance Resonant Mode Controller |
| NCP1395BDR2G | High Performance Resonant Mode Controller |
| NCP1395BPG | High Performance Resonant Mode Controller |
| NCP1395A | High Performance Resonant Mode Controller(高性能諧振模式控制器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| NCP1382DR2G | 功能描述:電流型 PWM 控制器 L-STNDBY PWM CNTRLR RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| NCP1392B | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:High-Voltage Half-Bridge Driver with Inbuilt Oscillator |
| NCP1392B_09 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:High-Voltage Half-Bridge Driver with Inbuiltc Oscillator |
| NCP1392BDR2G | 功能描述:功率驅動器IC HV HALF-BRIDGE DRVER RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
| NCP1392DDR2G | 功能描述:功率驅動器IC HV HALF-BRIDGE DRIVER RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。