- 您現在的位置：買賣IC網 > PDF目錄98255 > TLV320DAC32IRHBR (TEXAS INSTRUMENTS INC) SERIAL INPUT LOADING, DAC WITH PROGRAMMABLE PLL, PQCC32 PDF資料下載
參數資料
| 型號： | TLV320DAC32IRHBR |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | DAC |
| 英文描述： | SERIAL INPUT LOADING, DAC WITH PROGRAMMABLE PLL, PQCC32 |
| 封裝： | 5 X 5 MM, GREEN, PLASTIC, QFN-32 |
| 文件頁數： | 16/69頁 |
| 文件大小： | 1242K |
| 代理商： | TLV320DAC32IRHBR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁
DIGITAL AUDIO DATA SERIAL INTERFACE
RIGHT JUSTIFIED MODE
BCLK
WCLK
SDIN
1
0
1
0
1/fs
LSB
MSB
LeftChannel
RightChannel
2
n1
n3
n2
n1
n3
n2
LEFT JUSTIFIED MODE
www.ti.com........................................................................................................................................ SLAS506B – NOVEMBER 2006 – REVISED DECEMBER 2008
Audio data is transferred between the host processor and the TLV320DAC32 via the digital audio data serial
interface, or “audio bus”. The audio bus of the TLV320DAC32 can be configured for left or right justified, I2S,
DSP, or TDM modes of operation, where communication with standard telephony PCM interfaces is supported
within the TDM mode. These modes are all MSB-first, with data width programmable as 16, 20, 24, or 32 bits. In
addition, the word clock (WCLK) and bit clock (BCLK) can be independently configured in either master or slave
mode, for flexible connectivity to a wide variety of processors.
The word clock (WCLK) is used to define the beginning of a frame, and may be programmed as either a pulse or
a square-wave signal. The frequency of this clock corresponds to the maximum DAC sampling frequency
selected.
The bit clock (BCLK) is used to clock in the digital audio data across the serial bus. When in master mode, this
signal can be programmed in two further modes: continuous transfer mode, and 256-clock mode. In continuous
transfer mode, only the minimal number of bit clocks needed to transfer the audio data are generated, so in
general the number of bit clocks per frame will be two times the data width. For example, if data width is chosen
as 16-bits, then 32 bit clocks will be generated per frame. If the bit clock signal in master mode will be used by a
PLL in another device, it is recommended that the 16-bit or 32-bit data width selections be used. These cases
result in a low jitter bit clock signal being generated, having frequencies of 32*Fs or 64*Fs. In the cases of 20-bit
and 24-bit data width in master mode, the bit clocks generated in each frame will not all be of equal period, due
to the device not having a clean 40*Fs or 48*Fs clock signal readily available. The average frequency of the bit
clock signal is still accurate in these cases (being 40*Fs or 48*Fs), but the resulting clock signal has higher jitter
than in the 16-bit and 32-bit cases and may reduce the overall DAC performance.
In 256-clock mode, a constant 256 bit clocks per frame are generated, independent of the data width chosen. By
using this capability with the ability to program at what bit clock in a frame the audio data will begin, time-division
multiplexing (TDM) can be accomplished, resulting in multiple DACS able to use a single audio serial data bus.
When the audio serial data bus is powered down while configured in master mode, the pins associated with the
interface will be put into a tri-state output condition.
In right-justified mode, the LSB of the left channel is valid on the rising edge of the bit clock preceding the falling
edge of word clock. Similarly, the LSB of the right channel is valid on the rising edge of the bit clock preceding
the rising edge of the word clock.
Figure 26. Right Justified Serial Bus Mode Operation
In left-justified mode, the MSB of the right channel is valid on the rising edge of the bit clock following the falling
edge of the word clock. Similarly the MSB of the left channel is valid on the rising edge of the bit clock following
the rising edge of the word clock.
Copyright 2006–2008, Texas Instruments Incorporated
23
Product Folder Link(s): TLV320DAC32
相關PDF資料 |
PDF描述 |
|---|---|
| TLV320DAC32IRHBTG4 | SERIAL INPUT LOADING, DAC WITH PROGRAMMABLE PLL, PQCC32 |
| TLV320DAC32IRHBT | SERIAL INPUT LOADING, DAC WITH PROGRAMMABLE PLL, PQCC32 |
| TLV320DAC32IRHBRG4 | SERIAL INPUT LOADING, DAC WITH PROGRAMMABLE PLL, PQCC32 |
| TLV431AIDBV | 1-OUTPUT TWO TERM VOLTAGE REFERENCE, 1.24 V, PDSO5 |
| TLV431ALPRE | 1-OUTPUT TWO TERM VOLTAGE REFERENCE, PBCY3 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TLV320DAC32IRHBRG4 | 功能描述:音頻數/模轉換器 IC Lo-Pwr Stereo DAC RoHS:否 制造商:Texas Instruments 轉換器數量: 分辨率:16 bit 接口類型:I2S, UBS 轉換速率: 信噪比:98 dB 工作電源電壓:5 V DAC 輸出端數量:2 工作溫度范圍:- 25 C to + 85 C 電源電流:23 mA 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-32 封裝:Reel |
| TLV320DAC32IRHBT | 功能描述:音頻數/模轉換器 IC Low Power Stereo DAC RoHS:否 制造商:Texas Instruments 轉換器數量: 分辨率:16 bit 接口類型:I2S, UBS 轉換速率: 信噪比:98 dB 工作電源電壓:5 V DAC 輸出端數量:2 工作溫度范圍:- 25 C to + 85 C 電源電流:23 mA 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-32 封裝:Reel |
| TLV320DAC32IRHBTG4 | 功能描述:音頻數/模轉換器 IC Low Power Stereo DAC RoHS:否 制造商:Texas Instruments 轉換器數量: 分辨率:16 bit 接口類型:I2S, UBS 轉換速率: 信噪比:98 dB 工作電源電壓:5 V DAC 輸出端數量:2 工作溫度范圍:- 25 C to + 85 C 電源電流:23 mA 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-32 封裝:Reel |
| TLV320DAC33NIZQC | 制造商:Texas Instruments 功能描述: |
| TLV320DAC33NIZQCR | 制造商:Texas Instruments 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。