- 您現在的位置：買賣IC網 > PDF目錄365968 > TSB14C01MHV IC APEX 20KE FPGA 160K 484-FBGA PDF資料下載
參數資料
| 型號： | TSB14C01MHV |
| 英文描述： | IC APEX 20KE FPGA 160K 484-FBGA |
| 中文描述： | 收發器 |
| 文件頁數： | 32/35頁 |
| 文件大?。?/td> | 224K |
| 代理商： | TSB14C01MHV |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁當前第32頁第33頁第34頁第35頁
6
–
12
6.4.2
Fair Arbitration
When using this arbitration class, an active node can send an asynchronous packet exactly once each fairness
interval. Once a subaction gap is detected, a node can begin arbitration when its Arbitration_Enable signal is set. The
Arbitration_Enable signal is set at the beginning of the fairness interval and is cleared when the node successfully
accesses the bus through fair arbitration. This disables further fair arbitration attempts by that node for the remainder
of the fairness interval. In the absence of urgent nodes, a fairness interval ends once all of the nodes attempting fair
arbitration have successfully accessed the bus. At this time, all of the fair nodes have their Arbitration_Enable signals
reset and cannot arbitrate for the bus. The bus remains idle until an arbitration reset gap occurs. Once this happens,
the next fairness interval begins. All of the nodes set their Arbitration_Enable signal and can begin to arbitrate for the
bus. This process is illustrated in Figure 6
–
10.
arb
arb
arb
arb
Node A
Node B
Node C
Clear When Node Wins Arbitration
Set at Arbitration Reset Gap
Note: Arbitration Number of A > B > C
Fairness Interval N
Fairness
Interval N
–
1
Fairness
Interval N+1
Node A
Node B
Node B
A
A
A
Figure 6
–
10. Fair Arbitration Timing
NOTE:
A node sending a concatenated subaction does not reset its Arbitration_Enable bit.
6.4.3
Urgent Arbitration
The backplane environment enhances the fair priority algorithm by splitting access opportunities among nodes based
on two priority classes: fair and urgent. Nodes using an urgent priority can use up to three-fourths of the access
opportunities, with the remaining equally shared among nodes using the fair priority. All nodes are required to
implement the fair priority class, while the urgent priority class is optional. Packets are labeled as urgent when that
priority class is used.
The fair/urgent allocation uses the same fairness interval described in fair arbitration but accompanies the
Arbitration_Enable flag with an Urgent_Count. The fair/urgent method works as follows:
When the bus is idle for longer than an arbitration reset gap, a fairness interval begins and all nodes set
their Arbitration_Enable flags, while nodes implementing urgent priority set their Urgent_Count to three.
A node that is waiting to send a packet using the fair priority class should begin arbitrating after detecting
a subaction gap as long as its Arbitration _Enable flag is set. When its Arbitration_Enable flag is cleared,
it waits for an arbitration reset gap before it begins arbitrating. When such a node wins an arbitration contest,
it sends a packet without the urgent label and its Arbitration_Enable flag is cleared.
A node that is waiting to send a packet with urgent priority begins arbitrating after detecting a subaction gap
if its Urgent_Count is nonzero. When its Urgent_Count is zero, it waits for an arbitration reset gap before
it begins arbitrating. Whenever such a node wins an arbitration contest, it sends a packet with the urgent
label.
相關PDF資料 |
PDF描述 |
|---|---|
| TSB14C01HV | 5-V IEEE 1394-1995 BACKPLANE TRANSCEIVER/ARBITER |
| TSB21LV03MHV | IC APEX 20KE FPGA 200K 484-FBGA |
| TSB21LV03CHV | IEEE 1394-1995 TRIPLE-CABLE TRANSCEIVER/ARBITER |
| TSB2203X6MMX30M | IC APEX 20KE FPGA 200K 240-PQFP |
| TSB2204.5X12MMX20M | IC APEX 20KE FPGA 200K 240-PQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TSB14C01PM | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| TSB15 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:EURO TERMINAL BLOCKS |
| TSB150002DS | 制造商:TE Connectivity 功能描述: |
| TSB150004DS | 制造商:TE Connectivity 功能描述:Conn Europa Terminal Blocks 8 POS 13.5mm Screw ST Cable Mount 40A/Contact |
| TSB150005 | 功能描述:柵欄接線端子 5P TERM BLOCK 13.5MM 300V 40A RoHS:否 制造商:TE Connectivity / AMP 產品:Barrier Terminal Blocks 系列: 類型:Dual Barrier, Flat Block without Mounting Ears 節距:9.53 mm 位置/觸點數量:2 線規量程:22-12 電流額定值:20 A 電壓額定值:300 V 安裝風格:Through Hole 安裝角:Vertical 端接類型:Screw 觸點電鍍:Tin |
發布緊急采購，3分鐘左右您將得到回復。