- 您現在的位置：買賣IC網 > Datasheet目錄58 > XBIB-U (Digi International/Maxstream)BOARD USB ZIGBEE MOD PRO Datasheet資料下載
參數資料
| 型號： | XBIB-U |
| 廠商： | Digi International/Maxstream |
| 文件頁數： | 52/72頁 |
| 文件大小： | 1116K |
| 描述： | BOARD USB ZIGBEE MOD PRO |
| 設計資源： | XBIB-U Shematic |
| 標準包裝： | 1 |
| 附件類型： | 接口板 |
| 適用于相關產品： | XBee 和 XBee Pro 收音機 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁當前第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁
XBee/XBeePRO"燨EM燫F燤odules??02.15.4?爒1.xAx燵2007.05.031]
2007燤axStream,營nc.
牋牋?2
Chapter??燫F燤odule燙onfiguration
SM (Sleep Mode) Command
<Sleep Mode (Low Power)> The SM command is
used to set and read Sleep Mode settings. By
default, Sleep Modes are disabled (SM = 0) and
the RF module remains in Idle/Receive Mode.
When in this state, the module is constantly
ready to respond to either serial or RF activity.
SM command options vary according to the net-
working system type. By default, the module is
configured to operate in a NonBeacon system.
* The Sleep Coordinator option (SM=6) only
exists for backwards compatibility with firmware
version 1.x06 only. In all other cases, use the CE
command to enable a Coordinator.
SP (Cyclic Sleep Period) Command
<Sleep Mode (Low Power)> The SP command is
used to set and read the duration of time in which
a remote RF module sleeps. After the cyclic sleep
period is over, the module wakes and checks for
data. If data is not present, the module goes back
to sleep. The maximum sleep period is 268 sec-
onds (SP = 0x68B0).
The SP parameter is only valid if the module is
configured to operate in Cyclic Sleep (SM = 4-6).
Coordinator and End Device SP values should
always be equal.
To send Direct Messages, set SP = 0.
NonBeacon Firmware
End Device - SP determines the sleep period for cyclic sleeping remotes. Maximum sleep period is
268 seconds (0x68B0).
Coordinator - If non-zero, SP determines the time to hold an indirect message before discarding it.
A Coordinator will discard indirect messages after a period of (2.5 * SP).
ST (Time before Sleep) Command
<Sleep Mode (Low Power)> The ST command is
used to set and read the period of inactivity (no
serial or RF data is sent or received) before acti-
vating Sleep Mode.
NonBeacon Firmware
Set/Read time period of inactivity (no serial or RF
data is sent or received) before activating Sleep
Mode. ST parameter is only valid with Cyclic Sleep
settings (SM = 4 - 5).
Coordinator and End Device ST values must be equal.
AT Command: ATSM
Parameter Range: 0 - 6
Parameter
Configuration
0
Disabled
1
Pin Hibernate
2
Pin Doze
3
(reserved)
4
Cyclic Sleep Remote
5
Cyclic Sleep Remote
(with Pin Wake-up)
6
Sleep Coordinator*
Default Parameter Value: 0
Related Commands: SP (Cyclic Sleep Period),
ST (Time before Sleep)
AT Command: ATSP
Parameter
Range:
NonBeacon Firmware:
1 - 0x68B0 [x 10 milliseconds]
Default
Parameter
Value:
NonBeacon Firmware: 0
Related Commands: SM (Sleep Mode), ST
(Time before Sleep), DP (Disassociation Cyclic
Sleep Period, BE (Beacon Order)
AT Command: ATST
Parameter
Range:
NonBeacon Firmware:
1 - 0xFFFF [x 1 millisecond]
Default
Parameter
Value:
NonBeacon Firmware: 0x1388
(5000 decimal)
Related Commands: SM (Sleep Mode), ST
(Time before Sleep)
相關PDF資料 |
PDF描述 |
|---|---|
| XIB-E | BOARD INTERFACE ETHERNET |
| XIB-R | BOARD INTERFACE RS232/485 |
| ZMN2400HPDB | BOARD ROUTER DEV ZIGBEE 100MW |
| ZMN24HPDK-B | KIT DEV W/ZIGBEE ZMN2400HP |
| ZNI1000TC | IC TEMP SENSOR NI1000 SOT23-3 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XBIB-U-DEV | 功能描述:界面開發工具 USB XBee-PRO profes onal interface board RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V |
| XBIB-U-SP | 功能描述:界面開發工具 USB/Xbee/Xbee-Pro Inf Brd SMT Pads RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V |
| XBIB-U-SS | 功能描述:界面開發工具 USB/Xbee/Xbee-Pro Inf Brd SMT Skt RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V |
| XBL6450BYFVR | 制造商:Texas Instruments 功能描述:ECS BLUELINK - Tape and Reel |
| XBL6450YFHR | 制造商:Texas Instruments 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。