- 您現在的位置：買賣IC網 > PDF目錄360999 > ISP1301BS (NXP SEMICONDUCTORS) Universal Serial Bus On-The-Go transceiver PDF資料下載
參數資料
| 型號： | ISP1301BS |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 通用總線功能 |
| 英文描述： | Universal Serial Bus On-The-Go transceiver |
| 中文描述： | LINE TRANSCEIVER, PQCC24 |
| 封裝： | 4 X 4 MM, 0.85 MM HEIGHT, LEAD FREE AND HALOGEN FREE, PLASTIC, MO-220, SOT-616-1, HVQFN-24 |
| 文件頁數： | 8/46頁 |
| 文件大小： | 245K |
| 代理商： | ISP1301BS |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁
Philips Semiconductors
ISP1301
USB OTG transceiver
Product data
Rev. 01 — 14 April 2004
8 of 46
9397 750 11355
Koninklijke Philips Electronics N.V. 2004. All rights reserved.
8.4 ID detector
In either the active or suspended power mode, the ID detector senses the condition of
the ID line and differentiates between the following three conditions:
Pin ID is floating; bit ID_FLOAT = 1
Pin ID is shorted to ground; bit ID_GND = 1
Pin ID is connected to ground through resistor R
ACC_ID
; bit ID_FLOAT = 0 and bit
ID_GND = 0.
The ID detector also has a switch that can be used to ground pin ID. This switch is
controlled by bit ID_PULLDOWN in the serial controller.
8.5 Pull-up and pull-down resistors
The pull-up and pull-down resistors include the following switchable resistors:
Pin DP pull-up
Pin DP pull-down
Pin DM pull-up
Pin DM pull-down.
The pull-up resistor is a context variable as described in the ECN_27%_Resistor
document. The variable pull-up resistor hardware is implemented to meet the USB
ECN_27% specification.
8.6 USB transceiver (ATX)
The behavior of the USB transceiver depends on the operation mode of the ISP1301:
In the USB mode, the USB transceiver block performs USB full-speed or
low-speed transceiver functions. This includes differential driver, differential
receiver and single-ended receivers.
In the transparent general purpose buffer mode or the UART mode, the USB
transceiver block functions as a level shifter between the pins DAT/VP and SE0/VM
and the pins DP and DM.
8.7 3.3 V DC-DC regulator
The built-in 3.3 V DC-DC regulator conditions the supply voltage (V
BAT
) for use in the
ISP1301:
V
BAT
= 3.6 V to 4.5 V: the regulator will output 3.3 V
±
10 %
V
BAT
< 3.6 V: the regulator will be bypassed.
The output of the regulator can be monitored on the V
REG(3V3)
pin.
8.8 Car kit interrupt detector
The car kit interrupt detector is a comparator that detects when the DP line is below
the car kit interrupt threshold V
PH_CR_INT
(0.4 V to 0.6 V). The car kit interrupt
detector is enabled in the audio mode only (bit AUDIO_EN = 1).
相關PDF資料 |
PDF描述 |
|---|---|
| ISP1362 | Single-chip Universal Serial Bus On-The-Go controller |
| ISP1362BD | Single-chip Universal Serial Bus On-The-Go controller |
| ISP1362EE | Single-chip Universal Serial Bus On-The-Go controller |
| ISP1501 | Hi-Speed Universal Serial Bus peripheral transceiver |
| ISP1520 | Hi-Speed Universal Serial Bus hub controller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISP1301BS,115 | 功能描述:射頻收發器 USB OTG TRANSCEIVER RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| ISP1301BS,118 | 功能描述:射頻收發器 DO NOT USE ORDER -G OR -S PART RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| ISP1301BS,151 | 功能描述:射頻收發器 USB OTG TRANSCEIVER RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| ISP1301BS,157 | 功能描述:射頻收發器 DO NOT USE ORDER -G OR -S PART RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| ISP1301BSFA | 功能描述:IC USB OTG TRANSCEIVER 24HVQFN RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:25 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:4.5 V ~ 5.5 V 安裝類型:通孔 封裝/外殼:16-DIP（0.300"，7.62mm） 供應商設備封裝:16-PDIP 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。