- 您現在的位置：買賣IC網 > Datasheet目錄46 > SC418ULTRT (Semtech)IC REG DL BUCK/LINEAR 20MLPQ Datasheet資料下載
參數資料
| 型號： | SC418ULTRT |
| 廠商： | Semtech |
| 文件頁數： | 18/30頁 |
| 文件大小： | 691K |
| 描述： | IC REG DL BUCK/LINEAR 20MLPQ |
| 產品培訓模塊： | Power Supplies 101 |
| 標準包裝： | 1 |
| 系列： | EcoSpeed® |
| 拓撲： | 降壓（降壓）（1），線性（LDO）（1） |
| 功能： | 任何功能 |
| 輸出數： | 2 |
| 頻率 - 開關： | 1MHz |
| 電壓/電流 - 輸出 1： | 控制器 |
| 電壓/電流 - 輸出 2： | 0.75 V ~ 5.25 V，200mA |
| 帶 LED 驅動器： | 無 |
| 帶監控器： | 無 |
| 帶序列發生器： | 無 |
| 電源電壓： | 3 V ~ 28 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 20-MLPQ |
| 供應商設備封裝： | 20-MLPQ（3x3） |
| 包裝： | 標準包裝 |
| 其它名稱： | SC418ULTRTDKR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁
SC418
8
V
OUT
V
IN
+
CIN
Q2
+
D2
R
ILIM
C
BST
Q1
L
PGND
DL
ILIM
LX
DH
BST
C
OUT
Figure 9 Valley Current Limit
Setting the valley current limit to 0A results in a peak
inductor current of 0A plus peak ripple current. In this
situation the average current through the inductor is 0A
plus one-half the peak-to-peak ripple current.
The R
ILIM
value is calculated by the next equation.
A
10
I
R
R
LIM
DSON
ILIM
The internal 0糀 current source is temperature compen-
sated at 400ppm in order to provide tracking with the
RDS
ON
.
Note that MOSFET RDS
(ON)
increases significantly if the
VDDP voltage is 3.3V compared to 5.0V. When selecting
the R
ILIM
value, use the RDS
(ON)
value that corresponds to
the VDDP voltage used in the application.
Soft-Start of PWM Regulator
Soft-start is achieved in the PWM regulator by using an
internal voltage ramp as the reference for the FB compara-
tor. The voltage ramp is generated using an internal
charge pump which drives the reference from zero to
500mV in .2mV increments, using an internal 500kHz
oscillator. When the ramp voltage reaches 500mV, the
ramp is ignored and the FB comparator switches over to a
fixed 500mV threshold. During soft-start the output
voltage tracks the internal ramp, which limits the start-up
inrush current and provides a controlled soft-start profile.
Typical soft-start ramp time is 850約.
During soft-start the regulator turns off the low-side
MOSFET on any cycle if the inductor current falls to zero,
regardless of the psave setting. This prevents negative
inductor current, allowing the device to start into a pre-
biased output.
Power Good Output
The PGOOD (power good) output is an open-drain output
which requires a pull-up resistor. When the voltage at the
FB pin is 0% below the nominal voltage, PGOOD is pulled
low. It remains low until the FB voltage returns above -8%
of nominal. During start-up PGOOD is held low and will
not be allowed to transition high until the PGOOD start-
up delay fime has passed and soft-start is completed
(when V
FB
reaches 500mV). The delay time starting from
EN going high is typically 2ms for VDDA = 5V and ms for
VDDA = 3.3V.
PGOOD will transition low if the FB voltage exceeds +20%
of nominal (600mV), which is also the over-voltage shut-
down threshold. PGOOD also pulls low if the EN pin is low
when VDDA is present.
Output Over-Voltage Protection
OVP (Over-voltage protection) becomes active as soon as
the device is enabled. The OVP threshold is set at 500mV
+ 20% (600mV). When V
FB
exceeds the OVP threshold, DL
latches high and the low-side MOSFET is turned on. DL
remains high and the controller remains off until the EN
input is toggled or VDDA is cycled. There is a 5約 delay
built into the OVP detector to prevent false transitions.
PGOOD is also low after an OVP event.
Output Under-Voltage Protection
When V
FB
falls 25% below its nominal voltage (falls to
375mV) for eight consecutive clock cycles, the switcher is
shut off and the DH and DL drives are pulled low to tri-
state the MOSFETs. The controller stays off until EN is
toggled or VDDA is cycled.
VDDA UVLO and POR
The VDDA Under-Voltage Lock-Out (UVLO) circuitry inhib-
its switching and tri-states the DH/DL drivers until VDDA
rises above 2.9V. When VDDA exceeds 2.9V, an internal
POR (Power-On Reset) resets the fault latch and the soft-
start counter and then the SC48 begins the soft-start
Applications Information (continued)
相關PDF資料 |
PDF描述 |
|---|---|
| SC424MLTRT | IC REG DL BUCK/LINEAR 28MLPQ |
| SC4250LISTRT | IC HOT SWAP CTRLR 8-SOIC |
| SC427MLTRT | IC REG DL BUCK/LINEAR 32MLPQ |
| SE95D,112 | IC SENSOR TEMP 2.8-5.5V SOT96-1 |
| SE97BTP,547 | IC TEMP SENSOR DIMM 8HWSON |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SC419 | 制造商:SEMTECH 制造商全稱:Semtech Corporation 功能描述:EcoSpeedTM DC-DC Converter with Integrated Boost Diode |
| SC419970CGCR2 | 制造商:Motorola Inc 功能描述: |
| SC419EVB | 制造商:SEMTECH 制造商全稱:Semtech Corporation 功能描述:EcoSpeedTM DC-DC Converter with Integrated Boost Diode |
| SC419ULTRT | 功能描述:IC REG CTRLR BUCK PWM 20-MLPQ RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:EcoSpeed®, SmartDrive™ 特色產品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 標準包裝:1 系列:PowerWise® PWM 型:電壓模式 輸出數:1 頻率 - 最大:1MHz 占空比:81% 電源電壓:4.5 V ~ 18 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-5°C ~ 125°C 封裝/外殼:32-WFQFN 裸露焊盤 包裝:Digi-Reel® 產品目錄頁面:1303 (CN2011-ZH PDF) 其它名稱:LM3754SQDKR |
| SC41E6 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:SIEMENS ANNOUNCES A SUB-MICTON GENERATION OF CHANNELLESS GATE-ARRAYS BASED ON THE PROVEN MEGALOGIC PROCESS |
發布緊急采購，3分鐘左右您將得到回復。