- 您現在的位置：買賣IC網 > PDF目錄98285 > TPS65040ZQER (TEXAS INSTRUMENTS INC) 8-CHANNEL POWER SUPPLY MANAGEMENT CKT, PBGA71 PDF資料下載
參數資料
| 型號： | TPS65040ZQER |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 電源管理 |
| 英文描述： | 8-CHANNEL POWER SUPPLY MANAGEMENT CKT, PBGA71 |
| 封裝： | 5 X 5 MM, 0.50 MM PITCH, GREEN, PLASTIC, MICRO, BGA-71 |
| 文件頁數： | 38/73頁 |
| 文件大小： | 1928K |
| 代理商： | TPS65040ZQER |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁當前第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁
BUCK-BOOST DC/DC CONVERTER POWER-UP SEQUENCE AND MODE STATE DESCRIPTION
Power-Up Sequence
PABIAS1 Pin Input Voltage Range
Disable Mode
Active Discharge When Disable Mode
Idle Mode
Softstart Mode
Normal Operation Mode
SLVS708B – NOVEMBER 2006 – REVISED APRIL 2007
Table 2. Low/High Control for External DC/DC Converter (continued)
REG_EN(1)
VIO1V8(1)
TXONFST
r[PSCNTDC/DC_EXT]
EXT_DC_DC_ON_OFF
1
0
Low
1
0
Low
0
Don't Care
Low
1
0
Don't Care
Low
Pin PABIAS1 controls the output voltage and must have an input to set the output voltage before power up of
the DC/DC converter. If PABIAS1 pin has an unknown voltage, the DC/DC converter can not regulate the output
voltage; and, the device or peripheral components may be damaged. Figure 72 shows the power-up sequence
for the DC/DC converter: (a) via an external pin controlled by TXONFST, and (b) via a register command control.
Figure 72 shows each mode from OFF (Disable Mode) to ON (Normal Operation Mode). The following
paragraphs give more details.
The input voltage range of PABIAS1 pin is from 0.4 V to 2.414 V. This range keeps the output voltage of the
DC/DC converter at the proper level. Also, it must be input before power-up of the DC/DC converter.
Table 1 shows the buck-boost DC/DC converter is disabled when TXONFST = Low, or r[PSCNTDC/DC] = Low.
Then the analog circuit of Figure 70 is disabled and the logic circuit is reset. Also, current-limit protection and
short-circuit protection are disabled.
VOUT output is pulled down to 0V when the buck-boost DC/DC converter is disabled. Then MN1, MP2 = ON
and MP1, MN2 = OFF in Figure 70. VOUT pin is pulled down to 0V via the coil, but when VOUT is below 0.6 V,
the discharging speed is at a gentle slope. Because the power supply of the MN2 and its gate driver buffer in
Figure 70 are supplied from VOUT, the MN2 cannot discharge the VOUT to 0V.
Table 1 shows the DC/DC converter is enabled when TXONFST = High and r[PSCNTDC/DC] = High. Figure 72
shows each mode during power-up sequence. Since the analog circuit is unstable, output transistors (MP1,
MN1, MP2, MN2) operate after 50
s (typ), counted by an internal oscillator. After the count-up it shifts to
softstart mode. Current-limit protection and short-circuit protection are disabled. Figure 72 shows the same
sequence; that is, TXONFST turns from low to high at r[PSCNTDC/DC] = High, and r[PSCNTDC/DC] turns low
to high at TXONFST = High.
Softstart mode operates to avoid rush current when the buck-boost DC/DC converter activates the output
transistor via idle mode. Internal VREF_SS ramps up within 500
s (max) by counter, when idle mode shifts to
softstart mode. Output voltage is set by PABIAS1 pin. The time of softstart mode depends on the value of the
output voltage. SS_OK = High finishes softstart mode when VREF_SS is counted up. After completing softstart
mode, current-limit protection and short-circuit protection start operation simultaneously.
Normal operation mode provides line regulation, load regulation, and fast transient response control by the
analog input of PABIAS1 pin. Current-limit and short-circuit protection are enabled continuously.
43
相關PDF資料 |
PDF描述 |
|---|---|
| TPS650531IRGERQ1 | POWER SUPPLY SUPPORT CKT, PQCC24 |
| TPS650532RGET | 5-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC24 |
| TPS650531RGER | 5-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC24 |
| TPS65055RSMR | 1.8 A DUAL SWITCHING CONTROLLER, 2475 kHz SWITCHING FREQ-MAX, PQCC32 |
| TPS65058RGET | 1.8 A DUAL SWITCHING CONTROLLER, 2475 kHz SWITCHING FREQ-MAX, PQCC32 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS65050EVM-195 | 功能描述:電源管理IC開發工具 TPS65050-195 Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| TPS65050RSMR | 功能描述:PMIC 解決方案 6-Ch Pwr Mgmt IC RoHS:否 制造商:Texas Instruments 安裝風格:SMD/SMT 封裝 / 箱體:QFN-24 封裝:Reel |
| TPS65050RSMRG4 | 功能描述:PMIC 解決方案 6Ch Pwr Mgmt IC RoHS:否 制造商:Texas Instruments 安裝風格:SMD/SMT 封裝 / 箱體:QFN-24 封裝:Reel |
| TPS65050RSMT | 功能描述:PMIC 解決方案 6-Channel Power Management IC RoHS:否 制造商:Texas Instruments 安裝風格:SMD/SMT 封裝 / 箱體:QFN-24 封裝:Reel |
| TPS65050RSMTG4 | 功能描述:PMIC 解決方案 6-Ch Pwr Mgmt IC RoHS:否 制造商:Texas Instruments 安裝風格:SMD/SMT 封裝 / 箱體:QFN-24 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。