- 您現在的位置：買賣IC網 > PDF目錄98285 > TPS65200YFFR (TEXAS INSTRUMENTS INC) 1-CHANNEL POWER SUPPLY SUPPORT CKT, BGA36 PDF資料下載
參數資料
| 型號： | TPS65200YFFR |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 電源管理 |
| 英文描述： | 1-CHANNEL POWER SUPPLY SUPPORT CKT, BGA36 |
| 封裝： | 2.80 X 2.60 MM, 0.40 MM PITCH, GREEN, DSBGA-36 |
| 文件頁數： | 12/59頁 |
| 文件大小： | 2424K |
| 代理商： | TPS65200YFFR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁當前第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁
SLVSA48 – APRIL 2010
www.ti.com
DESCRIPTION
The TPS65200 integrates a high-efficiency, USB-friendly switch-mode charger with OTG support for single-cell
Li-ion and Li-polymer batteries, D+D- detection, a 50-mA fixed-voltage LDO, a high-efficiency WLED boost
converter, and high-accuracy current-shunt monitor into a single chip.
The charger features a synchronous 3-MHz PWM controller with integrated power MOSFETs, input current
sensing and regulation, input-voltage dynamic power management, high-accuracy charge current and voltage
regulation, and charge termination. It charges the battery in three phases: low-current pre-charge, constant
current fast-charge, and constant voltage trickle-charge. The input current is automatically limited to the value set
by the host. The charger can be configured to terminate charge based on user-selectable minimum current level
and to automatically restart the charge cycle if the battery voltage falls below the recharge threshold. A safety
timer with reset control provides a safety backup for I2C interface. The charger automatically enters sleep mode
or high impedance mode when the input supply is removed. The charge status is reported to the host using the
I2C interface and STAT pin. The D+D- detection circuit allows automatic detection of a USB wall-charger. If a
wall-charger is detected the input current limit is automatically increased from 500 mA to 975 mA.
In OTG mode the PWM controller boosts the battery voltage to 5 V and provides up to 200-mA of current to the
USB output. At very light loads the boost operates in burst mode to optimize efficiency. OTG mode can be
enabled either through I2C interface or GPIO control.
The TPS65200 also provides a WLED boost converter with integrated 40-V switch FET, that drives up to 10
WLEDs in series. The boost converter runs at 600-kHz fixed switching frequency to reduce output ripple, improve
conversion efficiency, and allows for the use of small external components. The default WLED current is set with
a sense resistor, and the feedback voltage is regulated to 200 mV, as shown in the typical application. For
brightness dimming, the feedback voltage can be changed through the I2C interface or by application of a PWM
signal to the CTRL pin. In the latter case the feedback voltage is regulated down proportional to the PWM duty
cycle (analog dimming) rather than pulsing the LED current to avoid audible noise on the output capacitor. For
maximum protection, the device features integrated open LED protection that disables the TPS65200 to prevent
the output from exceeding the absolute maximum ratings during open LED conditions.
A fixed-gain, high-accuracy current shunt monitor senses the voltage drop across an external, 20-m
Ω sense
resistor and provides an analog output voltage that is proportional to the charge/discharge current of the battery.
The sense voltage is amplified by a factor of 25 and offset by VZERO, an externally provided reference voltage.
VZERO is internally buffered to avoid loading of the reference source.
The TPS65200 comes in a tiny, 2.8-mm x 2.6-mm, 36-ball, 0.4-mm pitch die size ball grid array (DSBGA) or a
6-mm x 6-mm, 0.5-mm pitch QFN.
2
Copyright 2010, Texas Instruments Incorporated
Product Folder Link(s): TPS65200
相關PDF資料 |
PDF描述 |
|---|---|
| TPS65251RHAT | SWITCHING REGULATOR, PQCC40 |
| TPS65251RHAR | SWITCHING REGULATOR, PQCC40 |
| TPS65257RHAT | 4 A SWITCHING REGULATOR, 2200 kHz SWITCHING FREQ-MAX, PQCC40 |
| TPS65510RGTRG4 | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC16 |
| TPS65510RGTTG4 | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC16 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS65200YFFT | 功能描述:PMIC 解決方案 Li+ Batt Chrgr RoHS:否 制造商:Texas Instruments 安裝風格:SMD/SMT 封裝 / 箱體:QFN-24 封裝:Reel |
| TPS65-201A-S | 功能描述:65MM RECTANGLE TRACKPAD 制造商:azoteq (pty) ltd 系列:IQ Switch?，ProxSense? 零件狀態:在售 傳感器類型:電容性 輸出類型:數字 工作溫度:0°C ~ 40°C 標準包裝:1 |
| TPS65203YFFR | 制造商:TI 功能描述:Ox Low End |
| TPS65217AEVM | 功能描述:電源管理IC開發工具 TPS65217A Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| TPS65217ARSLR | 功能描述:PMIC 解決方案 Sgl Chip Pwr Sol RoHS:否 制造商:Texas Instruments 安裝風格:SMD/SMT 封裝 / 箱體:QFN-24 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。