欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: TPS65200YFFR
廠商: TEXAS INSTRUMENTS INC
元件分類: 電源管理
英文描述: 1-CHANNEL POWER SUPPLY SUPPORT CKT, BGA36
封裝: 2.80 X 2.60 MM, 0.40 MM PITCH, GREEN, DSBGA-36
文件頁數: 21/59頁
文件大小: 2424K
代理商: TPS65200YFFR
VCSOUT < VSHORT ?
Regulate
Input Current ,
Change Current or
Voltage
-----------------
CHSTAT [2:0]=001
VBUS < VIN(MIN) ?
V
CSOUT < V SHORT ?
TERM _EN = 1 &
VCSOUT > VOREG – VRCH &
ITERM detected
NO
Enable ISHORT
-----------------
CHSTAT [2:0]=100
VBUS < VIN(MIN )
YES
Turn off Charge
-----------------
CHTERMI=1
YES
NO
YES
NO
ADAPTOR
DETECTION
CHARGE DONE
DELAY T INT
Turn off Charge
SLVSA48 – APRIL 2010
www.ti.com
Figure 47. Detailed Charging Flow Chart
Input Current Limiting and D+/D- Detection
By default the VBUS input current limit is set to 500 mA. When VBUS is asserted the TPS65200 performs a
charger source identification to determine if it is connected to a USB port or dedicated charger. This detection is
performed 200 ms after VBUS is asserted to ensure the USB plug has been fully inserted before identification is
performed. If a dedicated charger is detected the input current limit is increased to 975 mA, other wise the
current limit remains at 500 mA, unless changed by the user.
Automatic detection is performed only if VIO is below 0.6 V to avoid interfering with the USB transceiver which
may also perform D+/D- detection when the system is running normally. However, D+/D- can be initiated at any
time by the host by setting the DPDM_EN bit in the CONTROL register to 1. After detection is complete the
DPDM_EN bit is automatically reset to 0 and the detection circuitry is disconnected from the DP DM pins to avoid
interference with USB data transfer.
The input current limit can also be set through the I2C interface to 100 mA, 500 mA, 975 mA, or no limit by
writing to the CONFIG_B register. The effective current limit will be the higher of the D+D- detection result and
the IIN_LIMIT[1:0] setting in CONFIG_A register. Whenever VBUS drops below the UVLO threshold
IIN_LIMIT[1:0] is reset to 100-mA setting to avoid excessive current draw from an unknown USB port.
Once the input current reaches the input current limiting threshold, the charge current is reduced to keep the
input current from exceeding the programmed threshold. The host can choose to ignore the D+D- detection
result by setting the LMTSEL bit of the CONFIG_A register to 1.
28
Copyright 2010, Texas Instruments Incorporated
Product Folder Link(s): TPS65200
相關PDF資料
PDF描述
TPS65251RHAT SWITCHING REGULATOR, PQCC40
TPS65251RHAR SWITCHING REGULATOR, PQCC40
TPS65257RHAT 4 A SWITCHING REGULATOR, 2200 kHz SWITCHING FREQ-MAX, PQCC40
TPS65510RGTRG4 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC16
TPS65510RGTTG4 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC16
相關代理商/技術參數
參數描述
TPS65200YFFT 功能描述:PMIC 解決方案 Li+ Batt Chrgr RoHS:否 制造商:Texas Instruments 安裝風格:SMD/SMT 封裝 / 箱體:QFN-24 封裝:Reel
TPS65-201A-S 功能描述:65MM RECTANGLE TRACKPAD 制造商:azoteq (pty) ltd 系列:IQ Switch?,ProxSense? 零件狀態:在售 傳感器類型:電容性 輸出類型:數字 工作溫度:0°C ~ 40°C 標準包裝:1
TPS65203YFFR 制造商:TI 功能描述:Ox Low End
TPS65217AEVM 功能描述:電源管理IC開發工具 TPS65217A Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V
TPS65217ARSLR 功能描述:PMIC 解決方案 Sgl Chip Pwr Sol RoHS:否 制造商:Texas Instruments 安裝風格:SMD/SMT 封裝 / 箱體:QFN-24 封裝:Reel
主站蜘蛛池模板: 甘泉县| 利津县| 荆州市| 门头沟区| 封丘县| 阜宁县| 镇赉县| 公主岭市| 永嘉县| 高唐县| 新余市| 靖宇县| 安塞县| 沅江市| 长治市| 乐业县| 汶上县| 盐津县| 兴隆县| 青神县| 简阳市| 神池县| 灵山县| 金塔县| 屏南县| 茂名市| 循化| 农安县| 威远县| 乐东| 梅河口市| 沅江市| 新干县| 宁德市| 衢州市| 凤庆县| 洮南市| 定西市| 嘉鱼县| 当涂县| 唐海县|