- 您現在的位置：買賣IC網 > PDF目錄98285 > TPS65200YFFR (TEXAS INSTRUMENTS INC) 1-CHANNEL POWER SUPPLY SUPPORT CKT, BGA36 PDF資料下載
參數資料
| 型號： | TPS65200YFFR |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 電源管理 |
| 英文描述： | 1-CHANNEL POWER SUPPLY SUPPORT CKT, BGA36 |
| 封裝： | 2.80 X 2.60 MM, 0.40 MM PITCH, GREEN, DSBGA-36 |
| 文件頁數： | 26/59頁 |
| 文件大小： | 2424K |
| 代理商： | TPS65200YFFR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁當前第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁
Precharge
( Linear Charge)
Fast Charge
( PWM Charge)
ISHORT
Termination
V SHORT
Regulation
voltage
Precharge
Phase
Current Regulation
Phase
Voltage Regulation
Phase
Charge Current
Charge Voltage
The charging current during current regulation phase decreases as battery voltage
increases. This mode ensures fastest charging of the battery without exceeding the
adaptor current limit.
SLVSA48 – APRIL 2010
www.ti.com
Figure 53. Typical Charging Profile of TPS65200 With Input Current Limit
PWM Controller in Charge Mode
The TPS65200 provides an integrated, fixed 3-MHz frequency voltage-mode controller with feed-forward function
to regulate charge current or voltage. This type of controller is used to help improve line transient response,
thereby simplifying the compensation network used for both continuous and discontinuous current conduction
operation. The voltage and current loops are internally compensated using a Type-III compensation scheme that
provides enough phase margin for stable operation, allowing the use of small ceramic capacitors with very low
ESR. There is a 0.5-V offset on the bottom of the PWM ramp to allow the device to operate between 0% to
99.5% duty cycles.
The TPS65200 has two back-to-back common-drain N-channel MOSFETs at the high side and one N-channel
MOSFET at the low side. An input N-MOSFET (Q1) prevents battery discharge when VBUS is lower than
VCSOUT. The second high-side N-MOSFET (Q2) behaves as the switching control switch. A charge pump circuit is
used to provide gate drive for Q1, while a boot strap circuit with external boot-strap capacitor is used to boost up
the gate drive voltage for Q2.
Cycle-by-cycle current limit is sensed through the internal sense MOSFETs for Q2 and Q3. The threshold for Q2
is set to a nominal 1.9-A peak current. The low-side MOSFET (Q3) also has a current limit that decides if the
PWM controller will operate in synchronous or non-synchronous mode. This threshold is set to 100mA and it
turns off the low-side N-channel MOSFET (Q3) before the current reverses, preventing the battery from
discharging. Synchronous operation is used when the current of the low-side MOSFET is greater than 100 mA to
minimize power losses.
Battery Charging Process
During precharge phase, while the battery voltage is below the VSHORT threshold, the TPS65200 applies a
short-circuit current, ISHORT, to the battery. When the battery voltage is above VSHORT and below VOREG, the
charge current ramps up to fast charge current, IOCHARGE, or a charge current that corresponds to the input
current of IIN_LIMIT. The slew rate for fast charge current is controlled to minimize the current and voltage
over-shoot during transient. Both the input current limit (default at 100 mA), IIN_LIMIT, and fast charge current,
IOCHARGE, can be set by the host. Once the battery voltage is close to the regulation voltage, VOREG, the charge
current is tapered down as shown in Figure 52. The voltage regulation feedback occurs by monitoring the
battery-pack voltage between the CSOUT and PGND pins. TPS65200 is a fixed single-cell voltage version, with
adjustable regulation voltage (3.5 V to 4.44 V) programmed through I2C interface.
32
Copyright 2010, Texas Instruments Incorporated
Product Folder Link(s): TPS65200
相關PDF資料 |
PDF描述 |
|---|---|
| TPS65251RHAT | SWITCHING REGULATOR, PQCC40 |
| TPS65251RHAR | SWITCHING REGULATOR, PQCC40 |
| TPS65257RHAT | 4 A SWITCHING REGULATOR, 2200 kHz SWITCHING FREQ-MAX, PQCC40 |
| TPS65510RGTRG4 | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC16 |
| TPS65510RGTTG4 | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC16 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS65200YFFT | 功能描述:PMIC 解決方案 Li+ Batt Chrgr RoHS:否 制造商:Texas Instruments 安裝風格:SMD/SMT 封裝 / 箱體:QFN-24 封裝:Reel |
| TPS65-201A-S | 功能描述:65MM RECTANGLE TRACKPAD 制造商:azoteq (pty) ltd 系列:IQ Switch?，ProxSense? 零件狀態:在售 傳感器類型:電容性 輸出類型:數字 工作溫度:0°C ~ 40°C 標準包裝:1 |
| TPS65203YFFR | 制造商:TI 功能描述:Ox Low End |
| TPS65217AEVM | 功能描述:電源管理IC開發工具 TPS65217A Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| TPS65217ARSLR | 功能描述:PMIC 解決方案 Sgl Chip Pwr Sol RoHS:否 制造商:Texas Instruments 安裝風格:SMD/SMT 封裝 / 箱體:QFN-24 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。