欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: TSB41LV03PFP
英文描述: IC APEX 20KE FPGA 600K 652-BGA
中文描述: 收發器
文件頁數: 41/50頁
文件大小: 662K
代理商: TSB41LV03PFP
SLLS418G
JUNE 2000
REVISED JANUARY 2003
41
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
PRINCIPLES OF OPERATION
transmit (continued)
00
00
00
00
(e)
(d)
(c)
(b)
(a)
01
00
00
00
11
D0
D7
CTL0, CTL1
SYSCLK
00
Link Controls CTL and D
PHY High-Impedance CTL and D Outputs
Figure 21. Cancelled/Null Packet Transmission
The sequence of events for a cancelled/null packet transmission is as follows:
1
a.
Transmit operation initiated. PHY asserts grant on the CTL lines followed by idle to hand over control
of the interface to the link.
b.
Optional idle cycle. The link may assert at most one idle cycle preceding assertion of hold. This idle cycle
is optional; the link is not required to assert idle preceding hold.
c.
Optional hold cycles. The link may assert hold for up to 47 cycles preceding assertion of idle. These
hold cycle(s) are optional; the link is not required to assert hold preceding idle.
d.
Null transmit termination. The null transmit operation is terminated by the link asserting two cycles of
idle on the CTL lines and then releasing the interface and returning control to the PHY. Note that the
link may assert idle for a total of three consecutive cycles if it asserts the optional first idle cycle but does
not assert hold. It is recommended that the link assert three cycles of idle to cancel a packet
transmission if no hold cycles are asserted. This ensures that either the link or PHY controls the
interface in all cycles.
e.
After regaining control of the interface, the PHY asserts at least one cycle of idle before any subsequent
status transfer, receive operation, or transmit operation.
interface reset and disable
The LLC controls the state of the PHY-LLC interface using the LPS signal. The interface may be placed into a
reset state, a disabled state, or be made to initialize and then return to normal operation. When the interface
is not operational (whether reset, disabled, or in the process of initialization) the PHY cancels any outstanding
bus request or register read request, and ignores any requests made via the LREQ line. Additionally, any status
information generated by the PHY is not queued and does not cause a status transfer upon restoration of the
interface to normal operation.
The LPS signal may be either a level signal or a pulsed signal, depending upon whether the PHY-LLC interface
is a direct connection or is made across an isolation barrier. When an isolation barrier exists between the PHY
and LLC (whether of the TI bus-holder type or Annex J type) the LPS signal must be pulsed. In a direct
connection, the LPS signal may be either a pulsed or a level signal. Timing parameters for the LPS signal are
given in Table 21.
相關PDF資料
PDF描述
TSB41AB2I IEEE 1394a-2000 TWO-PORT CABLE TRANSCEVER/ARBITER
TSB41LV03AI IEEE 1394a THREE-PORT CABLE TRANSCEIVER/ARBITER
TSC692E 672-pin FineLine BGA
TSC695F IC,FPGA,57120-CELL,CMOS,BGA,1020PIN,PLASTIC
TSC695FL IC,FPGA,79040-CELL,CMOS,BGA,1020PIN,PLASTIC
相關代理商/技術參數
參數描述
TSB41LV03PFP WAF 制造商:Texas Instruments 功能描述:
TSB41LV04A 制造商:TI 制造商全稱:Texas Instruments 功能描述:IEEE 1394a FOUR-PORT CABLE TRANSCEIVER/ARBITER
TSB41LV04APFP 功能描述:總線收發器 Four-Port Cable Xcvr/Arbiter RoHS:否 制造商:Fairchild Semiconductor 邏輯類型:CMOS 邏輯系列:74VCX 每芯片的通道數量:16 輸入電平:CMOS 輸出電平:CMOS 輸出類型:3-State 高電平輸出電流:- 24 mA 低電平輸出電流:24 mA 傳播延遲時間:6.2 ns 電源電壓-最大:2.7 V, 3.6 V 電源電壓-最小:1.65 V, 2.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TSSOP-48 封裝:Reel
TSB41LV04APFPG4 功能描述:1394 接口集成電路 Four-Port Cable Xcvr/Arbiter RoHS:否 制造商:Texas Instruments 類型:Link Layer Controller 工作電源電壓: 封裝 / 箱體:LQFP 封裝:Tray
TSB41LV06 制造商:TI 制造商全稱:Texas Instruments 功能描述:IEEE 1394a SIX-PORT CABLE TRANSCEIVER/ARBITER
主站蜘蛛池模板: 太白县| 兰西县| 卓尼县| 东乌| 喀喇| 海阳市| 鄂州市| 莫力| 资兴市| 屏南县| 乐平市| 志丹县| 五常市| 财经| 百色市| 洮南市| 永靖县| 武邑县| 高青县| 庆阳市| 固镇县| 香港| 确山县| 班玛县| 澎湖县| 牡丹江市| 贺州市| 城口县| 永善县| 沾益县| 剑河县| 两当县| 台江县| 万盛区| 洞口县| 平塘县| 石狮市| 高尔夫| 英德市| 大丰市| 琼结县|