- 您現在的位置：買賣IC網 > PDF目錄385345 > GS9090-CNE3 (Gennum Corporation) GS9090 GenLINX-R III 270Mb/s Deserializer for SDI and DVB-ASI PDF資料下載
參數資料
| 型號： | GS9090-CNE3 |
| 廠商： | Gennum Corporation |
| 英文描述： | GS9090 GenLINX-R III 270Mb/s Deserializer for SDI and DVB-ASI |
| 中文描述： | GS9090 GenLINX - R的第三270Mb / s的SDI和DVB解串器，意大利航天局 |
| 文件頁數： | 33/70頁 |
| 文件大小： | 696K |
| 代理商： | GS9090-CNE3 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁當前第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁
GS9090 Data Sheet
28201 - 1
July 2005
33 of 70
3.9.3 EDH Packet Detection
The GS9090 will determine if EDH packets are present in the incoming video data
and assert the EDH_DETECT output status signal appropriately.
EDH_DETECT will be set HIGH when EDH packets have been detected and will
remain HIGH until EDH packets are no longer present. The signal will be set LOW
at the end of the vertical blanking (falling edge of V) if an EDH packet has not been
received and detected during vertical blanking.
EDH_DETECT is available for output on the multi-function output port pins, if so
programmed (see
Programmable Multi-Function Outputs on page 56
).
Additionally, the EDH_DETECT bit is stored in the DATA_FORMAT register at
address 04h (see
Table 3-7
).
3.9.4 EDH Flag Detection
As described in
EDH Packet Detection on page 33
, the GS9090 can detect EDH
packets in the received data stream. The EDH flags for ancillary data, active
picture, and full field areas are extracted from the detected EDH packets and
placed in the EDH_FLAG_IN register of the device (
Table 3-5
).
When the EDH_FLAG_UPDATE bit in the DATA_FORMAT register (
Table 3-7
) is
set HIGH by the application layer, the GS9090 will update the ancillary data, full
field, and active picture EDH flags according to SMPTE RP165. The updated EDH
flags are placed in the EDH_FLAG_OUT register (
Table 3-6
). The EDH packet
output from the device will contain the updated flags.
One set of flags is provided for both fields 1 and 2. Field 1 flag data will be
overwritten by field 2 flag data.
When no EDH packets are detected (EDH_DETECT = LOW), the UES flags in the
EDH_FLAG_OUT register will be set HIGH to signify that the received signal does
not support the error detection practice. These flags are set regardless of the
setting of the EDH_FLAG_UPDATE bit.
NOTE: When EDH_FLAG_UPDATE is LOW with EDH packets in the video
stream, the content of the EDH_FLAG_OUT register is not valid and should be
ignored.
Both EDH_FLAG registers may be read by the host interface at any time during the
received frame except on the lines defined in SMPTE RP165 where these flags are
updated.
The GS9090 will also extract the CRC valid or ‘V’ bit for both active picture and full
field CRCs. The AP_CRC_V bit in the DATA_FORMAT register provides the active
picture CRC valid bit status, and the FF_CRC_V bit provides the full field CRC valid
bit status (see
Table 3-7
). When EDH_DETECT = LOW, these bits will be cleared.
The flag register values remain set until overwritten by the decoded flags in the
next received EDH packet in the following field. When no EDH packet is detected
during vertical blanking, the flag registers will be cleared at the end of the vertical
blanking period.
相關PDF資料 |
PDF描述 |
|---|---|
| GS9092A | GS9092A GenLINX-R III 270Mb/s Serializer for SDI and DVB-ASI |
| GS9092ACNE3 | GS9092A GenLINX-R III 270Mb/s Serializer for SDI and DVB-ASI |
| GS9092 | GS9092 GenLINX-R III 270Mb/s Serializer for SDI and DVB-ASI |
| GS9092-CNE3 | GS9092 GenLINX-R III 270Mb/s Serializer for SDI and DVB-ASI |
| GSC9620 | P-CHANNEL ENHANCEMENT MODE POWER MOSFET |
相關代理商/技術參數 |
參數描述 |
|---|---|
| GS9091B | 制造商:GENNUM 制造商全稱:GENNUM 功能描述:GenLINX II 270Mb/s Deserializer for SDI and DVB-ASI |
| GS9091BCBE3 | 功能描述:RF, RFID, WIRELESS RoHS:是 類別:集成電路 (IC) >> 接口 - 串行器，解串行器 系列:* 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- 功能:解串器 數據速率:2.5Gbps 輸入類型:串行 輸出類型:并聯 輸入數:- 輸出數:24 電源電壓:1.8 V ~ 3.3 V 工作溫度:-40°C ~ 105°C 安裝類型:表面貼裝 封裝/外殼:64-TQFP 裸露焊盤 供應商設備封裝:64-TQFP-EP（10x10） 包裝:管件 |
| GS9092 | 制造商:GENNUM 制造商全稱:GENNUM 功能描述:GS9092 GenLINX-R III 270Mb/s Serializer for SDI and DVB-ASI |
| GS9092A | 制造商:GENNUM 制造商全稱:GENNUM 功能描述:GS9092A GenLINX-R III 270Mb/s Serializer for SDI and DVB-ASI |
| GS9092A_10 | 制造商:GENNUM 制造商全稱:GENNUM 功能描述:GenLINX III 270Mb/s Serializer for SDI and DVB-ASI |
發布緊急采購，3分鐘左右您將得到回復。