- 您現在的位置：買賣IC網 > PDF目錄382301 > MC4GH02GNMCA-2SA00 (SAMSUNG SEMICONDUCTOR CO. LTD.) SAMSUNG MultiMediaCard PDF資料下載
參數資料
| 型號： | MC4GH02GNMCA-2SA00 |
| 廠商： | SAMSUNG SEMICONDUCTOR CO. LTD. |
| 英文描述： | SAMSUNG MultiMediaCard |
| 中文描述： | 三星多媒體 |
| 文件頁數： | 17/102頁 |
| 文件大小： | 1384K |
| 代理商： | MC4GH02GNMCA-2SA00 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁
MultiMediaCard
TM
17
Sep.22.2005
Revision 0.3
5.2.2 Power Protection
Cards shall be inserted/removed into/from the bus without damage. If one of the supply pins (V
DD
or V
SS
) is not connected
properly, then the current is drawn through a data line to supply the card. Every card’s output also shall be able to with-
stand shortcuts to either supply. If hot insertion feature is implemented in the host, than the host has to withstand a short-
cut between V
DD
and V
SS
without damage.
5.3 SPI Bus Topology
The SPI mode consists of a secondary, optional communication protocol which is offered by Flash-based MultiMedi-
aCards. This mode is a subset of the MultiMediaCard protocol, designed to communicate with a SPI channel. The Multi-
MediaCard SPI interface is compatible with SPI hosts available on the market. As in any other SPI device, the
MultiMediaCard SPI channel consists of the following four signals:
CS
: Host to card Chip Select signal
CLK
: Host to card clock signal
DataIn
: Host to card data signal
DataOut
: Card to host data signal
Another SPI common characteristic is byte transfers, which is implemented in the card as well. All data tokens are multi-
ples of bytes (8 bit) and always byte aligned to the CS signal.The SPI standard defines the physical link only, and not the
complete data transfer protocol.
The card identification and addressing methods are replaced by a hardware Chip Select (CS) signal. There are no broad-
cast commands. For every command, a card (slave) is selected by asserting (active low) the CS signal (see Figure ).
The CS signal must be continuously active for the duration of the SPI transaction (command, response and data). The
only exception occurs during card programming, when the host can de-assert the CS signal without affecting the program-
ming process.
The bidirectional CMD and DAT lines are replaced by unidirectional
dataIn
and
dataOut
signals. This eliminates the ability
to excute commands while data is being read or written which prevents swquential multi read/write operations. Only single
block read/write is supported by the SPI channel.
Figure 5-2 : MultiMediaCard Bus System
5.3.1 Power Protection
Power protection is the same as it is in MultiMediaCard mode.
SPI bus (CLK, DataIn, DataOut
)
SPI bus
master
Power
supply
CS
SPI
Card
相關PDF資料 |
PDF描述 |
|---|---|
| MC206 | THIN SMD LOW/MEDIUM-FREQUENCY CRYSTAL UNIT |
| MC2300 | Navigator Motion Processor |
| MC26LS30 | Dual Differential Quad Single-Ended (EIA-423-A) Line Drivers |
| MC26LS30D | CABLE GLAND, PG29 |
| MC26LS30DR2 | Dual Differential Quad Single-Ended (EIA-423-A) Line Drivers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC4M | 制造商:G & J HALL 功能描述:STEP DRILL MULTICUT 4-12MM X 2MM 制造商:G & J HALL 功能描述:STEP DRILL, MULTICUT, 4-12MM X 2MM |
| MC-4-MALE | 制造商:Multi-Contact USA 功能描述: |
| MC4MANUAL | 制造商:Omron Corporation 功能描述: |
| MC-4R128CEE6B | 制造商:NEC 制造商全稱:NEC 功能描述:Direct Rambus DRAM RIMM Module 128M-BYTE 64M-WORD x 16-BIT |
| MC-4R128CEE6B-653 | 制造商:NEC 制造商全稱:NEC 功能描述:Direct Rambus DRAM RIMM Module 128M-BYTE 64M-WORD x 16-BIT |
發布緊急采購，3分鐘左右您將得到回復。