- 您現在的位置：買賣IC網 > PDF目錄382345 > MPC823 (Motorola, Inc.) Communication Processor Module PDF資料下載
參數資料
| 型號： | MPC823 |
| 廠商： | Motorola, Inc. |
| 英文描述： | Communication Processor Module |
| 中文描述： | 通信處理器模塊 |
| 文件頁數： | 8/74頁 |
| 文件大小： | 234K |
| 代理商： | MPC823 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁
Communication Processor Module
16-386
MPC823 REFERENCE MANUAL
MOTOROLA
S
C
1
P
AT—Address Type 1–3
These bits contain the function code value used during this SDMA channel memory
access. The AT0 pin is driven with a 1 to identify this SDMA channel access as a DMA
type.
MRBLR—Each serial management controller has one maximum receive buffer length
register that defines the length of the receive buffer. The MRBLR defines the maximum
number of bytes that the MPC823 writes to a receive buffer on a serial management
controller before it moves on to the next buffer. The MPC823 can write fewer bytes to
the buffer than MRBLR if a condition, such as an error or end-of-frame occurs, but it
never writes more bytes than the MRBLR value. It follows then, that the buffers you
supply must always be at least as long as the MRBLR. The transmit buffers for a serial
management controller are not affected in any way by the value programmed into the
MRBLR. Each transmit buffer can have a different length. You can choose the number
of bytes to be transmitted by programming the DATA LENGTH field in the TX buffer
descriptor.
RBPTR—The receiver buffer descriptor pointer for each SMCx channel points to the
next buffer descriptor the receiver transfers data to when it is idle or to the current buffer
descriptor during frame processing. After a reset or when the end of the buffer
descriptor table is reached, the communication processor module initializes this pointer
to the value programmed in the RBASE entry. Although you will not usually need to
write the RBPTR in most applications, you can modify it when the receiver is disabled
or when you are sure no receive buffer is currently being used.
TBPTR—The transmitter buffer descriptor pointer for each SMCx channel points to the
next buffer descriptor the transmitter transfers data from when it is idle or to the current
buffer descriptor during frame transmission. After a reset or when the end of the buffer
descriptor table is reached, the communication processor module initializes this pointer
to the value programmed in the TBASE register. Although you will not usually need to
write TBPTR in most applications, you can modify it when the receiver is disabled or
when you are sure no receive buffer is currently being used.
Note:
The MRBLR is not intended to be dynamically changed while a serial
management controller is operating. However, if it is modified in a single bus
cycle with one 16-bit move (not two 8-bit bus cycles back-to-back), then a
dynamic change in the receive buffer length can be successfully achieved. This
occurs when the communication processor module transfers control to the next
RX buffer descriptor in the table. Thus, a change to MRBLR does not have an
immediate effect. To guarantee that the change occurs on a particular RX buffer
descriptor, you must only change the MRBLR while the SMCx receiver is
disabled. The value of MRBLR must be greater than zero and it must be even if
the character length of the data is greater than 8 bits.
相關PDF資料 |
PDF描述 |
|---|---|
| MPC823UM_REV1_16-CPM7 | 10 AMP SUBMINIATURE POWER RELAY |
| MPC9109 | LOW VOLTAGE 1:18 CLOCK DISTRIBUTION CHIP |
| MPC9229 | 400 MHz Low Voltage PECL Clock Synthesizer |
| MPC9230 | 800 MHz Low Voltage PECL Clock Synthesizer |
| MPC9350 | LOW VOLTAGE PLL CLOCK DRIVER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MPC823CVR66B2T | 功能描述:微處理器 - MPU POWER QUICC RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
| MPC823CZQ66B2T | 功能描述:微處理器 - MPU PORTABLE SYSTEM MPU RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
| MPC823CZQ66B2T | 制造商:Freescale Semiconductor 功能描述:IC 32-BIT MPU 66MHZ 256-PBGA |
| MPC823ELD | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:MPC823e Mobile Computing Microprocessor |
| MPC823ELE | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:MPC823e Mobile Computing Microprocessor |
發布緊急采購，3分鐘左右您將得到回復。