- 您現在的位置：買賣IC網 > PDF目錄373975 > ADAU1702JSTZ-RL (ANALOG DEVICES INC) SigmaDSP 28-56-Bit Audio Processor with Two ADCs and Four DACs PDF資料下載
參數資料
| 型號： | ADAU1702JSTZ-RL |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 消費家電 |
| 英文描述： | SigmaDSP 28-56-Bit Audio Processor with Two ADCs and Four DACs |
| 中文描述： | SPECIALTY CONSUMER CIRCUIT, PQFP48 |
| 封裝： | ROHS COMPLIANT, PLASTIC, MS-026BBC, LQFP-48 |
| 文件頁數： | 11/52頁 |
| 文件大小： | 773K |
| 代理商： | ADAU1702JSTZ-RL |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁
ADAU1702
Pin No.
14
15
Rev. 0 | Page 11 of 52
Mnemonic
MP7
MP6
Type
1
D_IO
D_IO
Page No.
44
44
Description
Multipurpose GPIO or Serial Output Port Data 1 (SDATA_OUT1).
Multipurpose GPIO, Serial Output Port Data 0, or TDM Data Output
(SDATA_OUT0).
Multipurpose GPIO or Serial Output Port LRCLK (OUTPUT_LRCLK).
Drive for 1.8 V Regulator. The base of the voltage regulator external PNP
transistor is driven from VDRIVE.
Supply for Input and Output Pins. The voltage on this pin sets the highest
input voltage that should be seen on the digital input pins. This pin is also
the supply for the digital output signals on the control port and MP pins.
IOVDD should always be set to 3.3 V. The current draw of this pin is variable
because it is dependent on the loads of the digital outputs.
Multipurpose GPIO or Serial Output Port BCLK (OUTPUT_BCLK).
ADDR1: I
2
C Address 1. In combination with ADDR0, this sets the I
2
C address
of the IC so that four ADAU1702s can be used on the same I
2
C bus.
CDATA: SPI Data Input.
WB: EEPROM Writeback Trigger. A rising (default) or falling (if set in the
EEPROM messages) edge on this pin triggers a writeback of the interface
registers to the external EEPROM. This function can be used to save
parameter data on power-down.
CLATCH: SPI Latch Signal. Must go low at the beginning of an SPI transaction
and high at the end of a transaction. Each SPI transaction can take a different
number of CCLKs to complete, depending on the address and read/write bit
that are sent at the beginning of the SPI transaction.
WP: Self-Boot EEPROM Write Protect. This pin is an open-collector output
when in self-boot mode. The ADAU1702 pulls this low to prohibit writes to
an external EEPROM. This pin should be pulled high to 3.3 V.
SDA: I
2
C Data. This pin is a bidirectional open-collector. The line connected
to this pin should have a 2.2 kΩ pull-up resistor.
COUT: This SPI data output is used for reading back registers and memory
locations. It is three-stated when an SPI read is not active.
SCL: I
2
C Clock. This pin is always an open-collector input when in I
2
C control
mode. In self-boot mode, this pin is an open-collector output (I
2
C master).
The line connected to this pin should have a 2.2 kΩ pull-up resistor.
CCLK: SPI Clock. This pin can either run continuously or be gated off in
between SPI transactions.
Multipurpose GPIO, Serial Output Port Data 3 (SDATA_OUT3), or Auxiliary
ADC Input 0.
Multipurpose GPIO, Serial Output Port Data 2 (SDATA_OUT2), or Auxiliary
ADC Input 3.
Multipurpose GPIO, Serial Input Port Data 3 (SDATA_IN3), or Auxiliary
ADC Input 2.
Multipurpose GPIO, Serial Input Port Data 2 (SDATA_IN2), or Auxiliary
ADC Input 1.
Reserved. Tie to ground, either directly or through a pull-down resistor.
Crystal Oscillator Circuit Output. A 100 Ω damping resistor should be
connected between this pin and the crystal. This output should not be used
to directly drive a clock to another IC. If the crystal oscillator is not used, this
pin can be left disconnected.
Master Clock Input. MCLKI can either be connected to a 3.3 V clock signal or
can be the input from the crystal oscillator circuit.
PLL Ground Pin. The AGND, DGND, and PGND pins can be tied directly
together in a common ground plane. PGND should be decoupled to PVDD
with a 100 nF capacitor.
3.3 V Power Supply for the PLL and the Auxiliary ADC Analog Section. This
should be decoupled to PGND with a 100 nF capacitor.
PLL Loop Filter Connection. Two capacitors and a resistor need to be connected
to this pin, as shown in the Setting Master Clock/PLL Mode section.
3.3 V Analog Supply. This should be decoupled to AGND with a 100 nF capacitor.
PLL Mode Setting. PLL_MODE0 and PLL_MODE1 set the output frequency
16
17
MP10
VDRIVE
D_IO
A_OUT
44
5
18
IOVDD
PWR
19
20
MP11
ADDR1/CDATA/WB
D_IO
D_IN
44
22, 24, 26
21
CLATCH/WP
D_IO
24, 26
22
SDA/COUT
D_IO
21, 24
23
SCL/CCLK
D_IO
21, 24
26
MP9
D_IO/A_IO
44
27
MP8
D_IO/A_IO
44
28
MP3
D_IO/A_IO
44
29
MP2
D_IO/A_IO
44
30
31
RSVD
OSCO
X
D_OUT
17
32
MCLKI
D_IN
17
33
PGND
PWR
34
PVDD
PWR
35
PLL_LF
A_OUT
17
36, 48
38
AVDD
PLL_MODE0
PWR
D_IN
17
相關PDF資料 |
PDF描述 |
|---|---|
| ADC912A | CMOS Microprocessor-Compatible 12-Bit A/D Converter |
| ADC912AFP | CMOS Microprocessor-Compatible 12-Bit A/D Converter |
| ADC912AFS | CMOS Microprocessor-Compatible 12-Bit A/D Converter |
| ADCMP341 | Dual 0.275% Comparators and Reference with Programmable Hysteresis |
| ADCMP341_07 | Dual 0.275% Comparators and Reference with Programmable Hysteresis |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADAU1761 | 制造商:AD 制造商全稱:Analog Devices 功能描述:SigmaDSP Stereo, Low Power, 96 kHz, 24-Bit Audio Codec with Integrated PLL |
| ADAU1761BCPZ | 功能描述:IC SIGMADSP CODEC PLL 32LFCSP RoHS:是 類別:集成電路 (IC) >> 接口 - 編解碼器 系列:SigmaDSP® 標準包裝:2,500 系列:- 類型:PCM 數據接口:PCM 音頻接口 分辨率（位）:15 b ADC / DAC 數量:1 / 1 三角積分調變:是 S/N 比，標準 ADC / DAC (db):- 動態范圍，標準 ADC / DAC (db):- 電壓 - 電源，模擬:2.7 V ~ 3.3 V 電壓 - 電源，數字:2.7 V ~ 3.3 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:80-VFBGA 供應商設備封裝:80-BGA MICROSTAR JUNIOR（5x5） 包裝:帶卷 (TR) 其它名稱:296-21257-2 |
| ADAU1761BCPZ | 制造商:Analog Devices 功能描述:IC, AUDIO CODEC, 24BIT, 96KHZ, LFCSP-32 |
| ADAU1761BCPZ-R7 | 功能描述:IC SIGMADSP CODEC PLL 32LFCSP RoHS:是 類別:集成電路 (IC) >> 接口 - 編解碼器 系列:SigmaDSP® 標準包裝:2,500 系列:- 類型:立體聲音頻 數據接口:串行 分辨率（位）:18 b ADC / DAC 數量:2 / 2 三角積分調變:是 S/N 比，標準 ADC / DAC (db):81.5 / 88 動態范圍，標準 ADC / DAC (db):82 / 87.5 電壓 - 電源，模擬:2.6 V ~ 3.3 V 電壓 - 電源，數字:1.7 V ~ 3.3 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-WFQFN 裸露焊盤 供應商設備封裝:48-TQFN-EP（7x7） 包裝:帶卷 (TR) |
| ADAU1761BCPZ-RL | 功能描述:IC SIGMADSP CODEC PLL 32LFCSP RoHS:是 類別:集成電路 (IC) >> 接口 - 編解碼器 系列:SigmaDSP® 標準包裝:2,500 系列:- 類型:立體聲音頻 數據接口:串行 分辨率（位）:18 b ADC / DAC 數量:2 / 2 三角積分調變:是 S/N 比，標準 ADC / DAC (db):81.5 / 88 動態范圍，標準 ADC / DAC (db):82 / 87.5 電壓 - 電源，模擬:2.6 V ~ 3.3 V 電壓 - 電源，數字:1.7 V ~ 3.3 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-WFQFN 裸露焊盤 供應商設備封裝:48-TQFN-EP（7x7） 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。