- 您現在的位置：買賣IC網 > PDF目錄360999 > ISP1183BS (NXP SEMICONDUCTORS) Low-power Universal Serial Bus interface device with DMA PDF資料下載
參數資料
| 型號： | ISP1183BS |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 總線控制器 |
| 英文描述： | Low-power Universal Serial Bus interface device with DMA |
| 中文描述： | UNIVERSAL SERIAL BUS CONTROLLER, PQCC32 |
| 封裝： | 5 X 5 MM, 0.85 MM HEIGHT, PLASTIC, MO-220, SOT-617-1, HVQFN-32 |
| 文件頁數： | 10/62頁 |
| 文件大小： | 295K |
| 代理商： | ISP1183BS |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁
Philips Semiconductors
ISP1183
Low-power USB interface device with DMA
Product data
Rev. 01 — 24 February 2004
10 of 62
9397 750 11804
Koninklijke Philips Electronics N.V. 2004. All rights reserved.
[1]
Not driven LOW. There is, however, no current flow through the pads because no I/O supply voltage is
available. Therefore, no potential will develop at the output.
During the normal operation, when V
BUS
is available, pin SUSPEND is LOW. If there is no activity on
the USB bus for 3 ms or more, a suspend interrupt is generated on pin INT_N. On receiving the
suspend interrupt, the external processor issues a GOSUSP command to the device. Once the
GOSUSP command is issued by the processor, the device starts to prepare itself to go to the suspend
mode. During suspend, to reduce power consumption, the internal clocks can be shut down. Once the
device is completely ready to go into the suspend mode, it will assert pin SUSPEND HIGH and go into
the suspend mode. The typical time between the issuing of the GOSUSP command to the device and
the device asserting pin SUSPEND HIGH is approximately 2 ms.
Independent of the external reset. Depends only on the power-on reset.
On connecting the USB cable (V
BUS
), pin VBUSDET_N will change from HIGH level to LOW level in
approximately 2.5 ms to 3.5 ms.
[2]
[3]
[4]
8.11 Power supply
The ISP1183 is powered from a single supply voltage, ranging from 4.0 V to 5.5 V. An
integrated voltage regulator provides a 3.3 V supply voltage for the internal logic and
the USB transceiver. This voltage is available at pin V
REG(3V3)
for connecting an
external pull-up resistor on USB connection pin DP. See
Figure 3
.
The ISP1183 can also be operated from a 3.0 V to 3.6 V supply, as shown in
Figure 4
. In this case, the internal voltage regulator is disabled and pin V
REG(3V3)
must be connected to V
BUS
. For details, see
Section 19
.
8.12 Crystal oscillator
The ISP1183 has a crystal oscillator designed for a 6 MHz parallel-resonant crystal
(fundamental). A typical circuit is shown in
Figure 5
. Alternatively, an external clock
signal of 6 MHz can be applied to input XTAL1, while leaving output XTAL2 open.
SUSPEND
VBUSDET_N
DATA
H
H
Hi-Z
L
[1]
L
[1]
L
[1]
L
L
[3]
Hi-Z
L
H -> L
[4]
Hi-Z
L
L
-
Table 3:
Pin name
ISP1183 operation modes
…continued
Plug-out
state
Dead state
Reset state
Plug-in state
Normal state
Fig 3.
ISP1183 with a 4.0 V to 5.5 V supply.
Fig 4.
ISP1183 with a 3.0 V to 3.6 V supply.
VBUS
VREG(3V3)
VDD(I/O)
ISP1183
004aaa295
4.0 V to 5.5 V
VDD(I/O)
1.65 V to 3.6 V
VDD
8
12
18
30
21
3.0 V to 3.6 V
004aaa296
VBUS
VREG(3V3)
VDD(I/O)
VDD(I/O)
ISP1183
VDD
8
12
18
30
21
相關PDF資料 |
PDF描述 |
|---|---|
| ISP1301 | Universal Serial Bus On-The-Go transceiver |
| ISP1301BS | Universal Serial Bus On-The-Go transceiver |
| ISP1362 | Single-chip Universal Serial Bus On-The-Go controller |
| ISP1362BD | Single-chip Universal Serial Bus On-The-Go controller |
| ISP1362EE | Single-chip Universal Serial Bus On-The-Go controller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISP1183BS,118 | 功能描述:USB 接口集成電路 FULL-SPD USB2 DEVICE RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20 |
| ISP1183BS,151 | 功能描述:USB 接口集成電路 FULL-SPD USB2 DEVICE RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20 |
| ISP1183BS,157 | 功能描述:USB 接口集成電路 DO NOT USE ORDER -S OR -T PART RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20 |
| ISP1183BSFA | 功能描述:IC USB HOST CTRL LOW-SPD 32HVQFN RoHS:是 類別:集成電路 (IC) >> 接口 - 專用 系列:- 標準包裝:3,000 系列:- 應用:PDA，便攜式音頻/視頻，智能電話 接口:I²C，2 線串口 電源電壓:1.65 V ~ 3.6 V 封裝/外殼:24-WQFN 裸露焊盤 供應商設備封裝:24-QFN 裸露焊盤（4x4） 包裝:帶卷 (TR) 安裝類型:表面貼裝 產品目錄頁面:1015 (CN2011-ZH PDF) 其它名稱:296-25223-2 |
| ISP1183BS-S | 功能描述:USB 接口集成電路 FULL-SPD USB2 DEVICE RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20 |
發布緊急采購，3分鐘左右您將得到回復。