欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號： MC68HC11A8MCFN2
廠商： MOTOROLA INC
元件分類： 微控制器/微處理器
英文描述： HCMOS Single-Chip Microcontroller
中文描述： 8-BIT, MROM, 2 MHz, MICROCONTROLLER, PQCC52
封裝： PLASTIC, LCC-52
文件頁數： 46/158頁
文件大小： 776K
代理商： MC68HC11A8MCFN2
MOTOROLA
5-2
SERIAL COMMUNICATIONS INTERFACE
MC68HC11A8
TECHNICAL DATA
5
1. The idle line is brought to a logic one state prior to transmission/reception of a
character.
2. A start bit (logic zero) is used to indicate the start of a frame.
3. The data is transmitted and received least-significant-bit first.
4. A stop bit (logic one) is used to indicate the end of a frame. A frame consists of
a start bit, a character of eight or nine data bits, and a stop bit.
5. A break is defined as the transmission or reception of a low (logic zero) for at
least one complete frame time.
Figure 5-1 Data Format
5.3 Wake-Up Feature
The receiver wake-up feature reduces SCI service overhead in multiple receiver sys-
tems. Software in each receiver evaluates the first character(s) of each message. If
the message is intended for a different receiver, the SCI can be placed in a sleep mode
so that the rest of the message will not generate requests for service. Whenever a new
message is started, logic in the sleeping receivers causes them to wake up so they
can evaluate the initial character(s) of the new message.
A sleeping SCI receiver can be configured (using the WAKE control bit in serial com-
munications control register 1 (SCCR1)) to wake up using either of two methods: idle
line wake up or address mark wake up.
In idle line wake up, a sleeping receiver wakes up as soon as the RxD line becomes
idle. Idle is defined as a continuous logic high on the RxD line for ten (or eleven) full
bit times. Systems using this type of wake up must provide at least one character time
of idle between messages to wake up sleeping receivers but must not allow any idle
time between characters within a message.
In address mark wake up, the most significant bit (MSB) in a character is used to indi-
cate that the character is an address (1) or a data (0) character. Sleeping receivers will
wake up whenever an address character is received. Systems using this method for
wake up would set the MSB of the first character in each message and leave it clear
for all other characters in the message. Idle periods may be present within messages
and no idle time is required between messages for this wake up method.
5.4 Receive Data (RxD)
Receive data is the serial data which is applied through the input line and the serial
communications interface to the internal bus. The receiver circuitry clocks the input at
a rate equal to 16 times the baud rate and this time is referred to as the RT clock.
0
1
2
3
4
5
6
7
8
*
0
IDLE LINE
SCI DATA FORMAT
1
START
STOP
START
* CONTROL BIT M IN SCCR1 SELECTS EITHER 8-BIT OR 9-BIT DATA.
相關PDF資料
PDF描述
MC68HC11A8BCFN2 HCMOS Single-Chip Microcontroller
MC68HC11A8BCFU2 HCMOS Single-Chip Microcontroller
MC68HC11A8BCP2 HCMOS Single-Chip Microcontroller
MC68HC11A8BMP2 HCMOS Single-Chip Microcontroller
MC68HC11A8BVP2 HCMOS Single-Chip Microcontroller
相關代理商/技術參數
參數描述
MC68HC11A8P1 制造商:Rochester Electronics LLC 功能描述:- Bulk
MC68HC11A8TS 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:8-Bit Microcontrollers
MC68HC11A8VCFN2 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:HCMOS Single-Chip Microcontroller
MC68HC11A8VCFU2 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:HCMOS Single-Chip Microcontroller
MC68HC11AOFNR2 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Motorola Inc 功能描述: 制造商:MOTOROLA 功能描述:
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*
主站蜘蛛池模板： 利辛县| 峡江县| 建水县| 泰宁县| 翼城县| 望谟县| 新巴尔虎左旗| 黄山市| 呼伦贝尔市| 马鞍山市| 黑龙江省| 孟村| 赫章县| 通州市| 理塘县| 海伦市| 普宁市| 嘉定区| 名山县| 卢龙县| 汤原县| 恩平市| 邢台县| 德清县| 滕州市| 新干县| 鹿邑县| 文登市| 清远市| 昌都县| 潞城市| 常山县| 怀仁县| 蓝田县| 万山特区| 徐水县| 南丹县| 金湖县| 吴堡县| 日土县| 奉化市|