- 您現在的位置：買賣IC網 > PDF目錄385311 > GS1559-CBE2 (Gennum Corporation) GS1559 HD-LINX-TM II Multi-Rate Deserializer with Loop-Through Cable Driver PDF資料下載
參數資料
| 型號： | GS1559-CBE2 |
| 廠商： | Gennum Corporation |
| 英文描述： | GS1559 HD-LINX-TM II Multi-Rate Deserializer with Loop-Through Cable Driver |
| 中文描述： | GS1559的HD - LINX進程，商標第二多速率解串器與環通電纜驅動器 |
| 文件頁數： | 35/74頁 |
| 文件大?。?/td> | 686K |
| 代理商： | GS1559-CBE2 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁當前第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁
GS1559 Data Sheet
30572 - 4
July 2005
35 of 74
The flywheel 'learns' the video standard by timing the horizontal and vertical
reference information contained in the TRS ID words of the received video stream.
Full synchronization of the flywheel to the received video standard therefore
requires one complete video frame.
Once synchronization has been achieved, the flywheel will continue to monitor the
received TRS timing information to maintain synchronization.
The FW_EN/DIS input pin controls the synchronization mechanism of the flywheel.
When this input signal is LOW, the flywheel will re-synchronize all pixel and line
based counters on every received TRS ID word.
When FW_EN/DIS is held HIGH, re-synchronization of the pixel and line based
counters will only take place when a consistent synchronization error has been
detected. Two consecutive video lines with identical TRS timing different to the
current flywheel timing must occur to initiate re-synchronization of the counters.
This provides a measure of noise immunity to internal and external timing signal
generation.
The flywheel will be disabled should the LOCKED signal or the RESET_TRST
signal be LOW. A LOW to HIGH transition on either signal will cause the flywheel
to re-acquire synchronization on the next received TRS word, regardless of the
setting of the FW_EN/DIS pin.
4.7.3 Switch Line Lock Handling
The principal of switch line lock handling is that the switching of synchronous video
sources will only disturb the horizontal timing and alignment of the stream, whereas
the vertical timing remains in synchronization.
To account for the horizontal disturbance caused by a synchronous switch, it is
necessary to re-synchronize the flywheel immediately after the switch has taken
place. Rapid re-synchronization of the GS1559 to the new video standard can be
achieved by controlling the flywheel using the FW_EN/DIS pin.
At every PCLK cycle the device samples the FW_EN/DIS pin. When a logic LOW
to HIGH transition at this pin is detected anywhere within the active line, the
flywheel will re-synchronize immediately to the next TRS word. This is shown in
Figure 4-2
.
To ensure switch line lock handling, the FW_EN/DIS signal should be LOW for a
minimum of one PCLK cycle (maximum one video line) anywhere within the active
portion of the line on which the switch has taken place.
相關PDF資料 |
PDF描述 |
|---|---|
| GS2905 | 500mA CMOS LDO Voltage Regulator |
| GS2905X15 | 500mA CMOS LDO Voltage Regulator |
| GS2905X18 | 500mA CMOS LDO Voltage Regulator |
| GS2905X25 | 500mA CMOS LDO Voltage Regulator |
| GS2905X33 | 500mA CMOS LDO Voltage Regulator |
相關代理商/技術參數 |
參數描述 |
|---|---|
| GS1560 | 制造商:GENNUM 制造商全稱:GENNUM 功能描述:HD-LINX II Voltage Controlled Oscillator |
| GS1560A | 制造商:Gennum Corporation 功能描述: |
| GS1560A_07 | 制造商:GENNUM 制造商全稱:GENNUM 功能描述:Dual-Rate Deserializer |
| GS1560A_09 | 制造商:GENNUM 制造商全稱:GENNUM 功能描述:HD-LINX II Dual-Rate Deserializer |
發布緊急采購，3分鐘左右您將得到回復。