- 您現在的位置：買賣IC網 > PDF目錄385311 > GS1559-CBE2 (Gennum Corporation) GS1559 HD-LINX-TM II Multi-Rate Deserializer with Loop-Through Cable Driver PDF資料下載
參數資料
| 型號： | GS1559-CBE2 |
| 廠商： | Gennum Corporation |
| 英文描述： | GS1559 HD-LINX-TM II Multi-Rate Deserializer with Loop-Through Cable Driver |
| 中文描述： | GS1559的HD - LINX進程，商標第二多速率解串器與環通電纜驅動器 |
| 文件頁數： | 51/74頁 |
| 文件大小： | 686K |
| 代理商： | GS1559-CBE2 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁當前第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁
GS1559 Data Sheet
30572 - 4
July 2005
51 of 74
4.10.5 Error Detection and Indication
The GS1559 contains a number of error detection functions to enhance operation
of the device when operating in SMPTE mode. These functions, (except lock error
detection), will not be available in either DVB-ASI or Data-Through operating
modes. See
DVB-ASI Functionality on page 41
and
Data Through Mode on
page 42
.
The device maintains an error status register at address 001
h
called
ERROR_STATUS (
Table 4-11
). Each type of error has a specific flag or bit in this
register which is set HIGH whenever that error is detected.
The ERROR_STATUS register will be cleared at the start of each video field or
when read by the host interface, which ever condition occurs first.
All bits of the ERROR_STATUS register except the LOCK_ERR bit will also be
cleared if a change in the video standard is detected, or under the following
conditions:
In addition to the ERROR_STATUS register, a register called ERROR_MASK
(
Table 4-12
) is included which allows the host interface to select the specific error
conditions that will be detected. There is one bit in the ERROR_MASK register for
each type of error represented in the ERROR_STATUS register.
RESET_TRST is held LOW
LOCKED is asserted LOW
SMPTE_BYPASS is asserted LOW in slave mode
The bits of the ERROR_MASK register will default to '0' after device reset, thus
enabling all error types to be detected. The host interface may disable individual
error detection by setting the corresponding bit HIGH in this register.
Error conditions are also indicated to the application layer via the status signal pin
DATA_ERROR. This output pin is a logical 'OR'ing of each error status flag stored
in the ERROR_STATUS register. DATA_ERROR is normally HIGH, but will be set
LOW by the device when an error condition that has not been masked is detected.
相關PDF資料 |
PDF描述 |
|---|---|
| GS2905 | 500mA CMOS LDO Voltage Regulator |
| GS2905X15 | 500mA CMOS LDO Voltage Regulator |
| GS2905X18 | 500mA CMOS LDO Voltage Regulator |
| GS2905X25 | 500mA CMOS LDO Voltage Regulator |
| GS2905X33 | 500mA CMOS LDO Voltage Regulator |
相關代理商/技術參數 |
參數描述 |
|---|---|
| GS1560 | 制造商:GENNUM 制造商全稱:GENNUM 功能描述:HD-LINX II Voltage Controlled Oscillator |
| GS1560A | 制造商:Gennum Corporation 功能描述: |
| GS1560A_07 | 制造商:GENNUM 制造商全稱:GENNUM 功能描述:Dual-Rate Deserializer |
| GS1560A_09 | 制造商:GENNUM 制造商全稱:GENNUM 功能描述:HD-LINX II Dual-Rate Deserializer |
發布緊急采購，3分鐘左右您將得到回復。