- 您現在的位置：買賣IC網 > PDF目錄382720 > UCB1500 (NXP SEMICONDUCTORS) PCI to AC97 bridge/host controller PDF資料下載
參數資料
| 型號： | UCB1500 |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 總線控制器 |
| 英文描述： | PCI to AC97 bridge/host controller |
| 中文描述： | PCI BUS CONTROLLER, PQFP80 |
| 封裝： | 12 X 12 MM, 1.40 MM HEIGHT, PLASTIC, MS-026, SOT-315-1, LQFP-80 |
| 文件頁數： | 45/58頁 |
| 文件大小： | 1001K |
| 代理商： | UCB1500 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁當前第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁
Philips Semiconductors
UCB1500
PCI to AC97 bridge/host controller
Objective specification
Rev. 01 — 4 February 2000
45 of 58
9397 750 06854
Philips Electronics N.V. 2000. All rights reserved.
9.2 Receive Descriptor Table format
When in receive mode, after receiving each frame, the DMA controller will update the
DT CMD/STT using a DMA cycle. Software can read the DT entry and determine the
status of the received data.
Table 69: Receive Descriptor Table format
Description
BASEADDR
Base address of the data buffer if the DT Link bit is not enabled.
Link pointer if the DT Link bit is enabled.
COUNT
Byte count of data buffer
CMD/STT
Command/status register (refer to
Table 70
).
Table 70: Command/status register bit description
Bit
Description
15
DT termination bit:
If set, the current entry is the last entry of the DT.
14
Reserved.
13
Invalid entry bit:
If set, it means that the current descriptor entry is not a valid
entry. For receive, this means the buffer corresponding to the descriptor is full,
and valid data is contained. If the UCB1500 reads a descriptor entry with this bit
set, it enters the hold condition (see hold condition section).
12-8
Reserved.
7
DT Link bit:
If set, the current descriptor entry is a link pointer to another
descriptor table. This bit is only valid when both bit[15] and bit[7] are set to 1.
Otherwise, this bit is undefined.
6
Interrupt bit:
Generate Receive DMA done interrupt at the completion of this DT
data entry.
5-0
Error Code
00 = No error
11 = DMA error
相關PDF資料 |
PDF描述 |
|---|---|
| UCC1913D | Very low drop voltage regulators with inhibit |
| UCC1913DTR | Analog IC |
| UCC1913J | Very low drop voltage regulators with inhibit |
| UCC1913N | Very low drop voltage regulators with inhibit |
| UCC1926DS | Very low drop voltage regulators with inhibit |
相關代理商/技術參數 |
參數描述 |
|---|---|
| UCB1510 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:AC97 digital modem codec |
| UCB15-101T-RC | 制造商:ALLIED 制造商全稱:Allied Components International 功能描述:Ultra Current Beads |
| UCB1510DB | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:AC97 digital modem codec |
| UCB15-121T-RC | 制造商:ALLIED 制造商全稱:Allied Components International 功能描述:Ultra Current Beads |
| UCB15-600T-RC | 制造商:ALLIED 制造商全稱:Allied Components International 功能描述:Ultra Current Beads |
發布緊急采購，3分鐘左右您將得到回復。