- 您現在的位置：買賣IC網 > PDF目錄98255 > TLV320DAC3120IRHBR (TEXAS INSTRUMENTS INC) SERIAL INPUT LOADING, 24-BIT DAC, PQCC32 PDF資料下載
參數資料
| 型號： | TLV320DAC3120IRHBR |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | DAC |
| 英文描述： | SERIAL INPUT LOADING, 24-BIT DAC, PQCC32 |
| 封裝： | 5 X 5 MM, PLASTIC, QFN-32 |
| 文件頁數： | 38/110頁 |
| 文件大小： | 1230K |
| 代理商： | TLV320DAC3120IRHBR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁當前第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁
www.ti.com
SLAS659 – NOVEMBER 2009
The headset detection block requires AVDD to be powered. The headset-detection feature in the
TLV320DAC3120 is achieved with very low power overhead, requiring less than 20
μA of additional
current from the AVDD supply.
5.6.4.8
Interrupts
Some specific events in the TLV320DAC3120, which may require host-processor intervention, can be
used to trigger interrupts to the host processor. This avoids polling the status-flag registers continuously.
The TLV320DAC3120 has two defined interrupts, INT1 and INT2, that can be configured by programming
page 0 / register 48 and page 0 / register 49. A user can configure interrupts INT1 and INT2 to be
triggered by one or many events, such as:
Headset detection
Button press
DAC DRC signal exceeding threshold
Noise detected by AGC
Overcurrent condition in headphone drivers/speaker drivers
Data overflow in the DAC processing blocks and filters
DC measurement data available
Each of these INT1 and INT2 interrupts can be routed to output pin GPIO1. These interrupt signals can
either be configured as a single pulse or a series of pulses by programming page 0 / register 48, bit D0
and page 0 / register 49, bit D0. If the user configures the interrupts as a series of pulses, the events
trigger the start of pulses that stop when the flag registers in page 0 / register 44, page 0 / register 45, and
page 0 / register 50 are read by the user to determine the cause of the interrupt.
5.6.5
Programming DAC Digital Filter Coefficients
The digital filter coefficients must be programmed through the I2C interface. All digital filtering for the DAC
signal path must be loaded into the RAM before the DAC is powered on. (Note that default ALLPASS filter
coefficients for programmable biquads are located in boot ROM. The boot ROM automatically loads the
default values into the RAM following a hardware reset (toggling the RESET pin) or after a software reset.
After resetting the device, loading boot ROM coefficients into the digital filters requires 100
μs of
programming time. During this time, reading or writing to page 8 through page 15 for updating DAC filter
coefficient values is not permitted. (The DAC should not be powered up until after all of the DAC
configurations have been done by the system microprocessor.)
5.6.6
Updating DAC Digital Filter Coefficients During PLAY
When it is required to update the DAC digital filter coefficients during play, care must be taken to avoid
click and pop noise or even a possible oscillation noise. These artifacts can occur if the DAC coefficients
are updated without following the proper update sequence. The correct sequence is shown in Figure 5-15.
The values for times listed in Figure 5-15 are conservative and should be used for software purposes.
There is also an adaptive mode, in which DAC coefficients can be updated while the DAC is on. For
details, see Section 5.6.1.3.
Copyright 2009, Texas Instruments Incorporated
APPLICATION INFORMATION
33
Product Folder Link(s): TLV320DAC3120
相關PDF資料 |
PDF描述 |
|---|---|
| TLV320DAC3120IRHBT | SERIAL INPUT LOADING, 24-BIT DAC, PQCC32 |
| TLV320DAC3202IYZJR | VOLUME CONTROL CIRCUIT, PBGA20 |
| TLV320DAC3202IYZJT | VOLUME CONTROL CIRCUIT, PBGA20 |
| TLV320DAC32IRHBR | SERIAL INPUT LOADING, DAC WITH PROGRAMMABLE PLL, PQCC32 |
| TLV320DAC32IRHBTG4 | SERIAL INPUT LOADING, DAC WITH PROGRAMMABLE PLL, PQCC32 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TLV320DAC3120IRHBT | 功能描述:音頻數/模轉換器 IC Lo-Pwr Audio DAC w/ Audio Proc RoHS:否 制造商:Texas Instruments 轉換器數量: 分辨率:16 bit 接口類型:I2S, UBS 轉換速率: 信噪比:98 dB 工作電源電壓:5 V DAC 輸出端數量:2 工作溫度范圍:- 25 C to + 85 C 電源電流:23 mA 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-32 封裝:Reel |
| TLV320DAC3120IRHBT | 制造商:Texas Instruments 功能描述:D/A Converter (D-A) IC 制造商:Texas Instruments 功能描述:IC, DAC, 32BIT, 192KSPS, QFN-32 |
| TLV320DAC32 | 制造商:BB 制造商全稱:BB 功能描述:LOW POWER STEREO AUDIO DAC FOR PORTABLE AUDIO/TELEPHONY |
| TLV320DAC3202 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:LOW POWER HIGH FIDELITY I2S INPUT HEADSET IC |
| TLV320DAC3202BYZJR | 功能描述:音頻數/模轉換器 IC Lo Pwr Hi Fidelity I2S Input Headset IC RoHS:否 制造商:Texas Instruments 轉換器數量: 分辨率:16 bit 接口類型:I2S, UBS 轉換速率: 信噪比:98 dB 工作電源電壓:5 V DAC 輸出端數量:2 工作溫度范圍:- 25 C to + 85 C 電源電流:23 mA 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-32 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。