欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號： TLV320DAC3120IRHBR
廠商： TEXAS INSTRUMENTS INC
元件分類： DAC
英文描述： SERIAL INPUT LOADING, 24-BIT DAC, PQCC32
封裝： 5 X 5 MM, PLASTIC, QFN-32
文件頁數： 43/110頁
文件大小： 1230K
代理商： TLV320DAC3120IRHBR
SLAS659 – NOVEMBER 2009
www.ti.com
5.6.9.1
Headphone Drivers
The TLV320DAC3120 features a mono headphone driver (HPOUT) that can deliver up to 30 mW per
channel, at 3.3-V supply voltage, into a 16-
load. The headphones are used in a single-ended
configuration where an ac-coupling (dc-blocking) capacitor is connected between the device output pins
and the headphones. The headphone driver also supports 32-
and 10-k loads without changing any
control register settings.
The headphone drivers can be configured to optimize the power consumption in the lineout-drive mode by
writing 11 to page 0 / register 44, bits D2–D1.
The output common mode of the headphone/lineout drivers can be programmed to 1.35 V, 1.5 V, 1.65 V,
or 1.8 V by setting page 1 / register 31, bits D4–D3. The common-mode voltage should be set
≤ AVDD/2.
The headphone driver can be powered on by writing to page 1 / register 31, bit D7. The HPOUT output
driver gain can be controlled by writing to page 1 / register 40, bits D6–D3, and it can be muted by writing
to page 1 / register 40, bit D2.
The TLV320DAC3120 has a short-circuit protection feature for the headphone drivers, which is always
enabled to provide protection. The output condition of the headphone driver during short circuit can be
programmed by writing to page 1 / register 31, bit D1. If D1 = 0 when a short circuit is detected, the device
limits the maximum current to the load. If D1 = 1 when a short circuit is detected, the device powers down
the output driver. The default condition for headphones is the current-limiting mode. In case of a short
circuit on either channel, the output is disabled and a status flag is provided as read-only bits on page 1 /
register 31, bit D0. If shutdown mode is enabled, then as soon as the short circuit is detected, page 1 /
register 31, bit D7 (for HPLOUT) clears automatically. Next, the device requires a reset to re-enable the
output stage. Resetting can be done in two ways. First, the device master reset can be used, which
requires either toggling the RESET pin or using the software reset. If master reset is used, it resets all of
the registers. Second, a dedicated headphone power-stage reset can also be used to re-enable the output
stage, and that keeps all of the other device settings. The headphone power stage reset is done by setting
page 1 / register 31, bit D7 for HPLOUT. If the fault condition has been removed, then the device returns
to normal operation. If the fault is still present, then another shutdown occurs. Repeated resetting (more
than three times) is not recommended, as this could lead to overheating.
5.6.9.2
Speaker Drivers
The TLV320DAC3120 has an integrated class-D mono speaker driver (SPKP/SPKM) capable of driving an
8-
or 4- differential load. The speaker driver can be powered directly from the battery supply (2.7 V to
5.5 V) on the SPKVDD pins; however, the voltage (including spike voltage) must be limited below the
absolute-maximum voltage of 6 V.
The speaker driver is capable of supplying 400 mW per channel with a 3.6-V power supply. Through the
use of digital mixing, the device can connect one or both digital audio playback data channels to either
speaker driver; this also allows digital channel swapping if needed.
The class-D speaker driver can be powered on by writing to page 1 / register 32, bit D7. The class-D
output-driver gain can be controlled by writing to page 1 / register 42, bits D4–D3, and it can be muted by
writing to page 1 / register 42, bit D2.
The TLV320DAC3120 has a short-circuit protection feature for the speaker drivers that is always enabled
to provide protection. If the output is shorted, the output stage shuts down on the overcurrent condition.
(Current limiting is not an available option for the higher-current speaker driver output stage.) In case of a
short circuit, the output is disabled and a status flag is provided as a read-only bit on page 1 / register 32,
bit D0.
38
APPLICATION INFORMATION
Copyright 2009, Texas Instruments Incorporated
Product Folder Link(s): TLV320DAC3120
相關PDF資料
PDF描述
TLV320DAC3120IRHBT SERIAL INPUT LOADING, 24-BIT DAC, PQCC32
TLV320DAC3202IYZJR VOLUME CONTROL CIRCUIT, PBGA20
TLV320DAC3202IYZJT VOLUME CONTROL CIRCUIT, PBGA20
TLV320DAC32IRHBR SERIAL INPUT LOADING, DAC WITH PROGRAMMABLE PLL, PQCC32
TLV320DAC32IRHBTG4 SERIAL INPUT LOADING, DAC WITH PROGRAMMABLE PLL, PQCC32
相關代理商/技術參數
參數描述
TLV320DAC3120IRHBT 功能描述:音頻數/模轉換器 IC Lo-Pwr Audio DAC w/ Audio Proc RoHS:否 制造商:Texas Instruments 轉換器數量: 分辨率:16 bit 接口類型:I2S, UBS 轉換速率: 信噪比:98 dB 工作電源電壓:5 V DAC 輸出端數量:2 工作溫度范圍:- 25 C to + 85 C 電源電流:23 mA 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-32 封裝:Reel
TLV320DAC3120IRHBT 制造商:Texas Instruments 功能描述:D/A Converter (D-A) IC 制造商:Texas Instruments 功能描述:IC, DAC, 32BIT, 192KSPS, QFN-32
TLV320DAC32 制造商:BB 制造商全稱:BB 功能描述:LOW POWER STEREO AUDIO DAC FOR PORTABLE AUDIO/TELEPHONY
TLV320DAC3202 制造商:TI 制造商全稱:Texas Instruments 功能描述:LOW POWER HIGH FIDELITY I2S INPUT HEADSET IC
TLV320DAC3202BYZJR 功能描述:音頻數/模轉換器 IC Lo Pwr Hi Fidelity I2S Input Headset IC RoHS:否 制造商:Texas Instruments 轉換器數量: 分辨率:16 bit 接口類型:I2S, UBS 轉換速率: 信噪比:98 dB 工作電源電壓:5 V DAC 輸出端數量:2 工作溫度范圍:- 25 C to + 85 C 電源電流:23 mA 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-32 封裝:Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*
主站蜘蛛池模板： 海丰县| 梁山县| 时尚| 康马县| 中阳县| 齐河县| 桂平市| 林州市| 永和县| 郴州市| 繁昌县| 庄浪县| 罗定市| 汤原县| 黄陵县| 舞钢市| 海兴县| 霍山县| 三原县| 宣武区| 长海县| 元谋县| 平乡县| 开封市| 建水县| 双城市| 鲁山县| 隆安县| 洪湖市| 岐山县| 宜川县| 大悟县| 蒙阴县| 衡阳县| 惠州市| 平江县| 尼勒克县| 务川| 天门市| 韩城市| 大丰市|