欧美成人免费电影,国产欧美一区二区三区精品酒店,精品国产a毛片,色网在线免费观看

參數資料
型號: PCF5083
廠商: NXP Semiconductors N.V.
英文描述: STEEL COVER
中文描述: GSM信號處理IC
文件頁數: 81/136頁
文件大小: 602K
代理商: PCF5083
1996 Oct 29
81
Philips Semiconductors
Objective specification
GSM signal processing IC
PCF5083
MP_convert_cmi
This procedure may be used to make a loopback between equalizer output
and burst builder input. It converts the 114 soft outputs (CMIs) of the
equalizer located in cmi_buff_id into 114 ‘hard’ bits. These bits are stored in
buffer info_buff_id.
MP_exec_reset
22
cmi_buff_id
info_buff_id
This procedure is used to execute a reset synchronous to the input
message queue. The difference to the RESET message is, that this
procedure is not executed immediately after it is found in the input queue.
The reset_action is the same as the one of the RESET message.
MP_if_enough_audio_in_samples
60
reset_action
This procedure is used for conditional execution of procedures. The
following n_procs procedures are executed if the audio input FIFO contains
at least n_samples samples, otherwise the procedures are skipped.
MP_iom2_disable
42
n_samples
n_procs
This procedure disables the IOM
-2 interrupts of the DSP. This results in a
reduced computational load of the DSP and therefore also in reduced
power consumption.
MP_iom2_enable
44
This procedure enables the IOM
-2 interrupts of the DSP. Sending or
receiving data over the IOM
-2 interface is only possible if this procedure
has been called. After reset the IOM
-2 interrupts are disabled. After the
call of MP_iom2_enable the audio FIFOs are initialized as follows: The
audio input FIFO contains 1 sample (value = 0xFFFD) and the audio output
FIFO contains 148 samples (value = 0xFFFD). This procedure must
therefore be called before the MP_AUDIO_SYNC procedure.
MP_offset_compensation
45
This procedure performs offset measurement and compensation. The
following function is performed:
(i_offset, q_offset) = EM_offset_measurement (n_samples)
MP_read_bbd_in_FIFO_init (i_offset, q_offset).
MP_read_audio_in_fifo
63
n_words words from the audio data input FIFO are copied to the buffer
buff_id in the DSP data memory. This FIFO collects the audio samples from
the ADC converter located in the handset. The procedure waits until the
FIFO contains sufficient data. The time-out is expressed in steps of 100
μ
s.
If time-out occurs a TIMEOUT_AUDIO_IN_FIFO error message is
automatically sent to the SC.
46
buff_id
n_words
timeout_val
DESCRIPTION
ID
PARAMETERS
RETURN
VALUES
相關PDF資料
PDF描述
PCF84C12A 8-BIT MICROCONTROLLER
PCF84C12AP 8-BIT MICROCONTROLLER
PCF84C12AT 8-BIT MICROCONTROLLER
PCF84C21A Telecom microcontrollers
PCF84C41A Telecom microcontrollers
相關代理商/技術參數
參數描述
PCF5083H/001/F2 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:GSM signal processing IC
PCF5083H/5V2/F3 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:GSM signal processing IC
PCF5083H/F2 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:GSM signal processing IC
PCF51AC128ACFUE 功能描述:32位微控制器 - MCU 32 Bit 128K FLASH 32K RAM CAN EN RoHS:否 制造商:Texas Instruments 核心:C28x 處理器系列:TMS320F28x 數據總線寬度:32 bit 最大時鐘頻率:90 MHz 程序存儲器大小:64 KB 數據 RAM 大小:26 KB 片上 ADC:Yes 工作電源電壓:2.97 V to 3.63 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:LQFP-80 安裝風格:SMD/SMT
PCF51AC128ACLKE 功能描述:32位微控制器 - MCU 32 Bit 128K FLASH 32K RAM CAN EN RoHS:否 制造商:Texas Instruments 核心:C28x 處理器系列:TMS320F28x 數據總線寬度:32 bit 最大時鐘頻率:90 MHz 程序存儲器大小:64 KB 數據 RAM 大小:26 KB 片上 ADC:Yes 工作電源電壓:2.97 V to 3.63 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:LQFP-80 安裝風格:SMD/SMT
主站蜘蛛池模板: 长岛县| 南昌市| 集贤县| 张家口市| 莎车县| 永清县| 收藏| 广元市| 平邑县| 客服| 南岸区| 虹口区| 静宁县| 左贡县| 信宜市| 深水埗区| 绵阳市| 科技| 河津市| 微山县| 越西县| 东乡族自治县| 二手房| 吉木萨尔县| 松潘县| 靖边县| 葵青区| 商南县| 张掖市| 宜川县| 佛坪县| 忻城县| 西平县| 屏南县| 大同市| 阳朔县| 龙游县| 运城市| 重庆市| 繁峙县| 汪清县|