
1996 Dec 11
62
Philips Semiconductors
Preliminary specification
Low voltage 16-bit microcontroller
P90CL301BFH (C100)
Notes
1.
The operating supply current through V
DD1
, V
DD2
and V
DD3
is measured with all output pins disconnected;
RESETIN = RESET = HALT = 0; A23 to A0 = V
DD
; D15 to D0 = V
DD
.
Idle and Standby current:
a) The Idle supply current through V
DD1
, V
DD2
and V
DD3
is measured with all port pins disconnected;
A23 to A0 = V
DD
; D15 to D0 = V
DD
; the circuit is executing NOP instructions from an external memory.
b) The Standby current through VDD1, VDD2 and VDD3 is measured with all port pins disconnected;
A23 to A0 = VDD; D15 to D0 = VDD;
The Power-down current through V
DD1
, V
DD2
and V
DD3
is measured with all output pins disconnected;
XTAL1 = RESET = HALTN = V
DD
; A23 to A0 = V
DD
; D15 to D0 = V
DD
; RESETIN = V
SS
.
See Table 95 for the different types.
Not tested in production.
Pull-ups:
a) These pull-ups are only present on the emulation pins PHALT and NMINE.
b) These active pull-ups are active on all WP2 WP4 port pins for output voltages greater than Vdd/2. They are only
active during the reset sequence on the pins CS0, CS1, R/W, CSBT and FETCH for test purpose.
c) These active pull-ups are only active on D15 to D0 and A23 to A0 pins when BPE is set in the SYSCON register.
2.
3.
4.
5.
6.
R
UP
R
UP2
R
UP3
R
STIN
pull-up resistor UP; note 6a
pull-up resistor UP2; note 6b
pull-up resistor UP3; note 6c
RESETIN resistor
16
8
70
15
26
15
100
31
60
30
500
120
k
k
k
k
SYMBOL
PARAMETER
CONDITIONS
MIN.
TYP.
MAX.
UNIT